1. FD supports
A.Jeremie

2. V-plate
T-plate

4. FD configuration (T.Okugi’s presentation)
Table=2400
IP=>
SBPM
QC3
FFTB
2.13
S3.00
SF1FF
QF1FF
100
450.1
200
180
SD0FF
QD0FF
76.2
785
380
2630
Sweeping
Honda
Shintake
S-band BPM slightly outside table on a “light” Sextupole=> how will the S-band BPM be supported?
Does this BPM need to be supported?

5. We must make the S-band BPM support adopter for SF1 and SD0,
because the weight of S-band BPMs are heavy.
Example of the BPM support
This is not the supports for SF1 and SD0

6. Compensate the height to reach beam height
Quadrupole with shims
LVDT to measure magnet position for mover control
mover
T-plate: same as before to keep same angle: only LVDT holes to be drilled
Change the way the mover is fixed on the table

7. sling
table
room for bolting
beeswax
3 plates

8. Set-up can be moved in the future 3 steel plates bolted to the floor
Honeycomb table
Bees wax
3 steel plates bolted to the floor
Bees wax: can be unglued, stable in time, good transmission of vibrations