1. MVB Assembly Instructions
©  All Rights Reserved to Mifram Ltd. 2018

2. Set of 8 MVB

4. About the MVB The Original modular vehicle barrier
When assembled units vertical element is impacted, it diverts the horizontal momentum into the ground.
The placement of the MVB is crucial. The Pictures demonstrate the correct orientation of the units
The open side of the L shaped unit is the side to face the threat and receive the impact

5. Mobillization

6. Orientation of Elements in direction of potential threat
(Open side of L shape)
in direction of potential threat
Direction of
Potential Threat
MVB Deployment

7. Safety Warning
Note that several parts are heavy (21 kg) and sharp. pay attention during unloading, assembling and packing
Elements Placed upright prior to being joined can fall on their side and create a hazard

8. Assembly instructions
MVB Deployment

9. Recommendations Deployment: If possible, Deploy the MVB where the
ramming car will be in the lower speed
by using nature obstacles like carves etc.
Block road sides and side walks.
Use warning lights and signs

10. System components

11. System components

12. System components

13. Unit’s Deployment

14. Pull out the safety pin

15. Pull out the yellow pin

16. Lift the upper part and insert the yellow pin

17. Reinsert the safety pin

18. Pull out the safety pin from mobile arm

19. Pull out the yellow pin

20. Lift the left mobile arm

21. Insert the yellow pin, as shown

22. Reinsert the safety pin in the rear

23. Pull out the safety pin from
the lower mobile arm

24. Join the mobile arm with the unit on the side

25. Reinsert the safety pin the below

26. Result

27. Assembling of the mobile system
Start from the right side
Insert the mobility rod as shown
Insert the rod, making sure the bolt is
align with the groove

28. Assembling of the mobile system

29. Assembling of the mobile system
Insert the rod, making sure the bolt is
align with the groove

30. Finish mobility rod insertion

31. Insert the next mobility rod, the same way

32. Insert safety pin

33. Lock the safety pin

34. Repeat the above steps as needed
in order to get required barrier width

35. Insert additional black bolt nearby the handle

36. Add end unit at side opposite the handle

37. Insert additional black bolt in the End unit

38. Insert the left side handle (option)

39. Insert the right side handle and secure it

41. Please contact us Thank you for purchasing Mifram MVB-3X.
with any question or information you may have.
Our customers support is happy to help you.
©  All Rights Reserved to Mifram Ltd. 2018