1. CH 104: DETERMINATION OF AN EQUILIBRIUM CONSTANT EQUILIBRIUM
Hydrogen (H2) and iodine (I2) react to produce hydroiodic acid (HI).
Forward Reaction: H2(g) + I2(g) → 2HI(g)
However, as soon as some HI is produced it begins to dissociate back to H2 and I2.
Reverse Reaction: 2HI(g) → H2(g) + I2(g)
These 2 opposing reactions, 1 forward and 1 reverse, go on simultaneously. Ultimately, the rate of the forward reaction will equal the rate of the reverse reaction and the system is in dynamic equilibrium.
H2(g) + I2(g) = 2HI(g)

2. EQUILIBRIUM
How many moles of H2(g), I2(g), and HI(g) are initially used in experiment 1?
H2(g) = moles, I2(g) = moles, and HI(g) = 0 moles.
How many moles of H2(g), I2(g), and HI(g) are initially used in experiment 2?
H2(g) = 0 moles, I2(g) = 0 moles, and HI(g) = moles.
How many moles of H2(g), I2(g), and HI(g) are initially used in experiment 3?
H2(g) = moles, I2(g) = moles, and HI(g) = moles.
In summary, all 3 experiments reach a dynamic equilibrium regardless of the initial concentrations of H2(g), I2(g), and HI(g).

3. EQUILIBRIUM
H2(g) + I2(g) = 2HI(g)
At equilibrium the rate of the forward reaction equals the rate of the reverse reaction. H2(g) and I2(g) are still producing HI(g). And HI(g) is still producing H2(g) and I2(g). However, the final concentrations of H2(g), I2(g), and HI(g) are constant.

4. EQUILIBRIUM
If the rate of people going to the first floor equals the rate of people going to the second floor, the number of people on each floor remains constant and the 2 groups are at dynamic equilibrium.

5. EQUILIBRIUM
For the general reaction:
aA + bB = cC + dD
Equilibrium Constant = Kc =
Where
[A], [B], [C], and [D] are the concentrations of reactants and products in moles per liter.
a, b, c, and d are the stoichiometric coefficients from the balance reaction.
Kc is the equilibrium constant.
The value of Kc depends on the particular reaction and on the temperature.
[C]c[D]d Products
[A]a[B]b Reactants

6. MEASURING AN EQUILIBRIUM CONSTANT
In today’s experiment you will measure the equilibrium constant (Kc) for the following reaction.
Fe3+ + SCN– = FeSCN2+
Kc =
Solutions of known iron(III) nitrate (Fe(NO3)3) and potassium thiocyanate (KSCN) will be mixed in prescribed proportions. The concentration of FeSCN2+ at equilibrium will be measured spectrophotometrically. These data will be used to calculate Kc.
[FeSCN2+]
[Fe3+][SCN–]

7. MEASURING AN EQUILIBRIUM CONSTANT
If mL of M Fe(NO3)3, 5.00 mL of M KSCN, and 5.00 mL of distilled water are mixed together, what is the initial concentration of Fe3+?
[Fe3+]initial = M
What is the initial concentration of SCN–?
[SCN–]initial = M
What is the initial concentration of FeSCN2+?
[FeSCN2+]initial = 0 M
If the concentration of FeSCN2+ at equilibrium is M, what is the equilibrium concentration of Fe3+?
Fe3+ + SCN– = FeSCN2+
[Fe3+]equilibrium = M – M = M
What is the equilibrium concentration of SCN–?
[SCN–]equilibrium = M – M = M

8. MEASURING AN EQUILIBRIUM CONSTANT
An ICE (Initial, Change, Equilibrium) table is used to solve these types of problems.
What is the equilibrium constant?
Kc =
Kc = = 3.6x102
Reaction:
Fe3+ +
SCN– =
FeSCN2+
Initial
concentrations: M M
0 M
Change:
– M M
Equilibrium M M M
[FeSCN2+]
[Fe3+][SCN–]
[ ]
[ ][ ]

9. SCHEMATIC OF A SPECTROPHOTOMETER
The most common light source for the visible region spectrophotometry is a tungsten filament incandescent lamp. A tungsten lamp emits useful light from approximately 325 nm to 3,000 nm.
A monochromator uses a prism or a diffraction grating to separate polychromatic (many wavelengths) light into monochromatic (single wavelength) light.
A cell or cuvette is used to hold the sample during analysis.
The detector uses a phototube or a photomultiplier tube to convert light into an electrical signal that is sent to a recorder or computer.

10. THE SPECTRONIC 20D SPECTROPHOTOMETER THE HACH DR2010 SPECTROPHOTOMETER
The controls.
Loading a sample.
THE HACH DR2010 SPECTROPHOTOMETER

11. ABSORBANCE AND CONCENTRATION
In today’s experiment you will use the Beer-Bouguer-Lambert law, more commonly called Beer’s law, to measure the equilibrium concentration of FeSCN2+.
A sample in a cell or cuvette during spectrophotometric analysis.
Po = the power of monochromatic light entering the sample.
P = the power of monochromatic light leaving the sample.
a = the absorptivity constant, which depends on the wavelength and the nature of the absorbing compound.
b = the path length through the absorbing compound.
c = the concentration of absorbing compound in the cuvette.

12. SOURCES
Beck, J Unit 3 Spectrophotometry. Available: [accessed 2 October 2006].
Christian, G.D Analytical Chemistry, 3rd ed. New York, NY: John Wiley & Sons, Inc.
Harris, D.C Quantitative Chemical Analysis, 5th ed. New York, NY: W.H. Freeman Company.
McMurry, J., R.C. Fay Chemistry, 4th ed. Upper Saddle River, NJ: Prentice Hall.
Petrucci, R.H General Chemistry Principles and Modern Applications, 4th ed. New York, NY: Macmillan Publishing Company.