1. Unit 1 Ch. 2 Mapping our World

2. What is a map?

3. Latitude and Longitude
A. The science of mapmaking is called cartography.
1. Cartographers use an imaginary grid of parallel lines and vertical lines to locate points on Earth exactly.

4. 2. The equator circles Earth halfway between the north and south poles.
3. The equator separates Earth into two equal halves called north and south hemispheres.

5. B. Latitude
1. Lines running parallel to the equator are called latitude.
2. Latitude is the distance in degrees north or south of the equator.
3. The equator is a reference point numbered at 0 degrees latitude.

7. C. Degrees of Latitude
  -Each 1 degree of latitude is equivalent to about 111km on Earth’s surface.
-Earth’s circumference is 40,000 km
-Earth is 360 degrees; 40,000/360 = 111
-Each degree is divided into 60 minutes (‘)= 1 min= 1.85 km
-Each minute is divided into 60 seconds (“)= 1 sec=

8. D. Longitude- east and west
1. Longitude is the distance in degrees east or west of the prime meridian, which is the reference point for longitude.

10. 2. The prime meridian represents 0 degrees longitude.
AM=___________
PM= ___________

11. 3. Unlike lines of latitude, lines of longitude are not parallel
3. Unlike lines of latitude, lines of longitude are not parallel. They are large semicircles that extend vertically from pole to pole
4. Both latitude and longitude are needed to precisely locate positions on earth.

12. E. Time Zones
1. Earth is divided into ____ time zones. Why?
2. Each time zone = _______degrees
-There are exceptions
3. USA has ___ time zones

14. F. Calendar dates
1. Each day ends and the next day begin at the stroke of mid night.
2. The International Date Line, or 180 degrees meridian, serves as the transition line for calendar days.

15. 3. If you were traveling west across the International Date Line, you would advance your calendar one-day.
4. If you were traveling east, you would move your calendar back one-day.

16. II. Types of Maps
1. MERCATOR PROJECTION: A map that has parallel lines of latitude and longitude.
Land mass shapes are correct, but distorted.
Used for navigation of ships
2. CONIC PROJECTION: A map projecting points and lines from globe onto a cone.
Distortion occurs near the top and bottom of the projection.
-Accurate for specific area; used for road maps & weather.

18. 3. A Gnomic Projection is made by projection points and lines from a globe onto a piece of paper that touches the globe at a single point.
-No distortion at a single point, but great amounts of distortion around the single point.
-Used for long route planning

20. 4. Detailed maps showing the hills and valleys of an area are called Topographic Maps.
5. Elevation on a topographic map is represented by a contour line.

22. 6. Contour line connects points of equal elevations.
7. The difference in elevation between two side-by-side contour lines is called the contour interval.

23. 8. Numbers representing their elevations marks some contour lines.
9. Depression contour lines are used to represent such features as volcanic craters and mines.

24. A. Map legends
1. A map legend explains what symbols represent.

25. 2. A map scale is the ratio between distances on a map and actual distances on the surface of Earth.
-Verbal (1cm=7 km)
-Graphic (Labeled line)
-Fractional (1:63000)

26. III. Remote sensing A. Electromagnetic spectrum
Process of collecting data about earth from far above the earth surface is called remote sensing.
2. Satellites detect different wavelengths of energy reflected or emitted from earth’s surface.

27. 3. All electromagnetic waves travel at the speed of 300 00 km/s – speed of light.
4. The arrangement of electromagnetic radiation according to wavelengths is called electromagnetic spectrum.

28. 5. An electromagnetic wave also can be described according to its frequency, which refers to then umber of waves that pass a particular point each second

30. B. Landsat satellites
1. A landsat satellite receives refelcted wavelengths of energy emitted by earth’s surface, including some wavelengths of visible light and infrared radiation.

32. 2. Other satellites, such as the Topex/Posedon satellite, use radar to map features on the ocean floor

34. 3. The global positioning system (GPS) is a radio-navigation system of at least 24 satellites that allows its users to determine their exact position on earth.

36. 1. 4. Sea beam technology is located on a ship rather than a satellite.
5. Sea beam relies on sonar-sound waves