1. Mechanical System P09045: Membrane Characterization Test Stand
1/16/2019 1

2. Test Stand Front View P09045: Membrane Characterization Test Stand
1/16/2019 2

3. Test Stand Angled Front View
P09045: Membrane Characterization Test Stand
P09045: Membrane Characterization Test Stand
1/16/2019 3

4. Test Stand Rear View P09045: Membrane Characterization Test Stand
1/16/2019 4

5. How it Works
Test stand is biaxial loader - pulls each side of the test specimen equally in both the x and y directions
Rod placed at a critical angle of 45 degrees for equal pulling in all direction
The apparatus uses linear ball bearings on the vertical and horizontal slide rods and needle bearings at all joints – minimizes friction
The motor turns a set of gears underneath the back plate, which will turn a set of opposite threaded lead screws threaded through the upper plate causing the loader to move up and down (depending on the rotation of the motor)
The design is compact because we are only looking to pull the specimen about an inch in all directions.
Needs work
P09045: Membrane Characterization Test Stand
P09045: Membrane Characterization Test Stand
1/16/2019 5

6. Moving Simulation P09045: Membrane Characterization Test Stand
1/16/2019 6