1. MMS / MBT / 04 – 160
Typical wire diameter from 0.20 to mm copper wire.
Electric connection by inserting 2 IDCs (after winding) or welding
Stack height from 25 to 125 mm or more
On the following page you will find the detailed operations of one machine and its layout

2. Manual coilformer loading and unloading
MMS / MBT / 04 – 160
The machine is based on the Sipro multishuttle transport system® with rotating spindles and independent
IDC insertion
Winding
Manual coilformer loading and unloading

3. MMS / MBT / 04 – 160 Manual parts loading and unloading
Tool design keeps these operations and specification change over simple

4. MMS / MBT / 04 – 160
Winding
4 spindle heavy duty tag wrapping winding machine
Coilformer transfer via shuttle
Programmable tensioners

5. MMS / MBT / 04 – 160 IDC insertion Bandoleer support
Stepping mechanism
Insertion device
Automatic stack height tolerance compensation

6. S/TBF/2 Specialized in pole chains
flyer winding head for 2 motors wound in parallel using programmable tensioners
modular design to suit higher production rates with additional winding heads
tool transfer to allow fully automatic motor assembly and wire connection and easy change over
phase 1
phase 2
phase 3
phase 1

7. S/TBF/2 Parts are fed and removed with their winding tool
programmable shuttle transfer between the loading station and the winding unit

8. S/TBF/2
The winding process is fully automatic and uses 4 programmable axes, wire holding clamps and pneumatic cutters for the winding start and finish.
Also the wire tension can be changed in any point of the winding in order to optimize the final result.

9. Production line Plastic hinges Cutting Winding 36 Stations S/TBF/2
1 milion motors per Year.
Plastic hinges Cutting
Winding 36 Stations S/TBF/2
Taper Control
Faston Insertion
Quality Vison Controls

10. interpolating Path Winder
iPW
interpolating Path Winder

11. interpolating Path Winder
iPW
interpolating Path Winder
Motor geometries represent a challenging task for winding machine designers.
Sipro has faced this challenge with a machine suitable for different motor designs just by changing its configuration to use a different winding technique:
A) segmented stators (single or pole chains)
B) inner or outer slot stators

12. interpolating Path Winder
iPW 02- HP
interpolating Path Winder
High Power
High speed Z-axis winding
Tilting of wire-guide tubes
Tooling X-axis for layering
Tooling Y-axis for wrapping
Tooling J-rot for tilting
Tooling W-rot for z rotation
Heavy Duty Applications

13. interpolating Path Winder
iPW 02- FW
interpolating Path Winder
Flat Wire
The coil turns around the wire.
Centre of rotation with controlled shifting
Flat Wire Applications

14. SIPRO SRL - Via priv. G. Natta 3, Lentate sul Seveso - MI (Italia) - Tel Fax –