Presentation is loading. Please wait.

Presentation is loading. Please wait.

Engineering Graphics I

Similar presentations


Presentation on theme: "Engineering Graphics I"— Presentation transcript:

1 Engineering Graphics 2018-19-I
Lecture 13 TA101A Engineering Graphics I By Dr. Mukesh Sharma Professor DEPARTMENT OF CIVIL ENGINEERING INDIAN INSTITUTE OF TECHNOLOGY KANPUR KANPUR , INDIA

2          

3 Mid-sem Examination: Preparation and readiness
Date – September 23, 2018 Venue: Drawing Hall Time: Slot-I: 8:00 AM to 10:00 AM; Sections A1 to A7 Slot-II: 10:30 AM to 12:30 PM; Sections A8 to A14 Be seated 15 mins before the start of exam Bring I-card and required drawing instruments Do not bring calculators or mobile Your bag should have only drawing instruments No paper, notes, any sheets or anything related to exam

4 Simple Object and Concept
Results of section at A-A will be reflected in the front view Results of section at B-B will be reflected in the side view Observe – (i) How to show section plane and what arrow means (ii) Hatching to differentiate solid and void/spaces

5 Spacing in hatch line 1.5 to 2 mm Do not measure by eye only.
Show three different pieces In section (change in direction) Line to indicate cutting plane - use little longer dashes Spacing in hatch line 1.5 to 2 mm Do not measure by eye only. Try drafters edge.

6 Full Section with Offset
A A Section A-A Full Section with Offset

7 Why Half section?

8 Pillow-block (Freehand sketch)
Disassembled Pillow-block                                 Pillow-block (Freehand sketch)                             

9 Full Section

10 SV- Section FV Half Section A-A

11 Showing cross section To save space Rotated Section
Rotate the section about vertical axis by 90 deg, Depth shown in width

12 Rotated section as broken view – when?
What if height of section view interferes with the view

13 Removed Sections - same purpose as rotated section
But for clarity remove the section and show it outside the main views

14

15 Example: Do not show hidden lines in Section; prefer B over A … but…this is not a rule

16 Show hidden lines in section
Prefer B over A – why?

17 Visible edges are shown after section; B is correct.
Adjacent Pieces… section line – change the angle of hatching lines

18 What not to section… Shafts, bolts nuts, pins, rivets ….. Not sectioned


Download ppt "Engineering Graphics I"

Similar presentations


Ads by Google