1. Avoiding unnecessary delays in the 802.11 WG Letter Ballot process
May 2006
doc.: IEEE /0528r0
May 2010
Avoiding unnecessary delays in the WG Letter Ballot process
Date:
Authors:
Adrian Stephens, Intel Corporation
Bruce Kraemer, Marvell

2. May 2010
Introduction
In the WG Letter ballot process, there are two decision points required to start a recirculation ballot
The decision to adopt comment resolutions
The decision to start a recirculation letter ballot
Both of these happen only at WG sessions
This process limits the rate of WG letter ballots to 1 per 2-month session cycle
This limitation does not create a problem during most of the letter ballot cycle. But near the end of the ballot cycle, it may introduce months of unnecessary delay.
Adrian Stephens, Intel Corporation

3. May 2010
Illustrated timing
Consider we’re nearing the end of a project, and are just about to produce D7 for ballot after the July meeting. We only expect to receive a few tens of comments in the next ballot.
We resolve these comments by rejecting them all – resulting in no changes to the draft. D7 is recirculated unchanged with these comment resolutions.
Using the current process, sponsor ballot starts in Nov.
Using the proposed process, sponsor ballot starts in Sept, saving 2 months.
Adrian Stephens, Intel Corporation

4. Example – The current process
May 2010
Example – The current process
Adrian Stephens, Intel Corporation

5. Example – The proposed process
May 2010
Example – The proposed process
Adrian Stephens, Intel Corporation

6. May 2010
FAQ
Are there any external rules describing the WG comment resolution process?
No. Not in any of the hierarchy of documents that form our P&P.
The best guidance comes “by analogy” from the IEEE-SA OM: “The Sponsor shall make a reasonable attempt to resolve all Do Not Approve votes that are accompanied by comments”. There is no description on how the sponsor organizes comment resolution, or decides that comment resolution is complete.
Adrian Stephens, Intel Corporation

7. May 2010
FAQ
Are there any external rules describing how a WG recirculation letter ballot is started?
The LMSC WG P&P states (9.4): “The working group shall be allowed to conduct votes between meetings at the discretion of the Chair by use of a letter or electronic ballot.” [my emphasis]
Stated responsibilities of the WG chair include (6.5.1):
“To place issues to a vote by WG members”
“To manage balloting of projects”
Conclusion: the LMSC rules give the WG chair freedom to start ballots, including WG recirculation letter ballots
Adrian Stephens, Intel Corporation

8. May 2010
Proposed Process
Once a TG has obtained “conditional approval to proceed to sponsor ballot”, the WG chair may delegate the responsibility for completing comment resolution to the TG chair.
The TG chair organizes TG meetings (telecons or F2F - with the usual rules about approval and announcement) to resolve comments. These meetings may vote on comment resolutions ( voting members only).
When comment resolution is complete, the WG chair starts any necessary recirculation ballot
Adrian Stephens, Intel Corporation

9. May 2010
Straw poll
Do you support the process shown on the previous slide, and agree that the OM should be updated to reflect this process?
Yes No
Abstain
Adrian Stephens, Intel Corporation