1. SETTING NETWORK BIAS AND TERMINATING RESISTORS
Communication & network
SETTING NETWORK BIAS AND TERMINATING RESISTORS
(VC1000)
The terminating resistors (TERM) must only be activated at the two extremities of the network.
The polarization resistors (BIAS) must only be activated on the unit controller.

2. SETTING NETWORK BIAS AND TERMINATING RESISTORS
Communication & network
SETTING NETWORK BIAS AND TERMINATING RESISTORS
(VC1000)
The terminating resistors (TERM) must only be activated at the two extremities of the network.
The polarization resistors (BIAS) must only be activated on the unit controller / T1000 digital sensor.

3. SETTING NETWORK BIAS AND TERMINATING RESISTORS
Communication & network
SETTING NETWORK BIAS AND TERMINATING RESISTORS
(M1000)
The terminating resistors (TERM) must only be activated at the two extremities of the network.
The polarization resistors (BIAS) must only be activated on the unit controller.

4. SETTING NETWORK ADDRESSES (VC1000)
Communication & network
SETTING NETWORK ADDRESSES (VC1000)

5. SETTING NETWORK ADDRESSES (VC1000)
Communication & network
SETTING NETWORK ADDRESSES (VC1000)
EACH CONTROLLER HAS A UNIQUE COMMUNICATION ADDRESS*
SWITCH # BINARY VALUE
# →
# →
# →
# →
# →
# →
# →
Up to 127x addresses are allowed
on a network
*Only VC1000 / M1000 controllers
have addresses set by dipswitches (hardware)
EX: Switches #1, #2 & #4 are set to ``ON’’
Address= = 11

6. VC1000 Zone controller Main components locations
NETWORK BUS TERMINATING RESISTORS
INTERFACE BUS TERMINATING RESISTORS
LED’s MONITORING LIGHTS
TERMINAL BLOCKS
MOTOR CLUTCH BUTTON
ADDRESSING DIP SWITCHES
DOs #1 TO #4 CONFIGURATION SWITCHES
RESET BUTTON

7. M1000 unit controller MULTIPLE UNITS IN A NETWORK NETWORK CONTROLLER
Network cable CAT5e
NETWORK CONTROLLER
PL-M1000 UNIT CONTROLLERS

8. M1000 unit controller
MULTIPLE NETWORKED UNITS

9. Remote Access Local Area Network (LAN) I.P: 192.168.1.99 (default)
or DHCP
ROUTER
Static I.P.
or dns
PL-NC-SCHED
PL-M1000
PL-VC-1000