1. Dr. Farzad Fariba دکتر فرزاد فریبا Farzad.faria@gmail.com
Continuume modeling
Dr. Farzad Fariba
دکتر فرزاد فریبا

3. Firstly, we draw approximately lines and then we can correcte them.
Here we draw in mm.
part
Firstly, we draw approximately lines and then we can correcte them.

4. Corrected
model 3

5. Approximately drawing of two curve

6. Correct the curves dimensions
Tangent the curves with lines

7. finally
Producing the fillet

9. properties 1

10. 3- assembely 1 2 3 4

11. 4- step 1 2 3

12. 5- bc
Symetric plate

13. We want to pressure load subject on half surface of the holl For this
Firstly, we must make partition In
Mesh part

14. 1 2 3

15. Repeat the similar actionTo
Anther supports

16. mesh

18. It’s not professional mesh
We must make part as partitioned

21. job

23. 1 2

24. For demonstraite of elements numbers

25. tables

26. Back to
variable
Remove tick