1. Dust Extractor
The dust extractor should always be turned on before cutting any piece of wood.
It can be turned on using the green button on the switchboard by the fire extinguisher.

2. Saw Blade
The saw blade is the most dangerous part of this machine. Before interacting with any part of the blade, ensure you isolate the power.
The guard must be in place when cutting wood, but must be lowered when adding/removing a blade.

3. Measurement Slider
The measurement slider allows for the precise and accurate cutting of wood.
This tool automatically measures the distance from the blade as you slide it across its rails.

4. The locking pin hole is where the locking pin should be inserted.
This allows for the blade’s nut to be turned without turning the blade around too. The locking pin should be inserted before adding or removing a blade.

5. Saw Terminal
The saw terminal is where you turn the saw on or off and adjust the blades height or angle.
The red button to the left is the power isolation switch. Push this to stop all power. Once power can be turned on again, spin this button to release.

6. Dust Extractor Terminal
The dust extractor terminal allows you to turn the dust extractor on and off.
Press the green button to start, and red to stop the extractor system. Always turn this on before using the table saw.