1. Point (Datum Point Tool)
Create a point on a corner.
Create a point on an edge/line.
Create a point by using sketch
Create a point by using offset coordinate system

2. Create a point on a corner
To create a point: Click Point -> Select a reference corner by click on it ->OK
Note: Turn on/off the switch to show the point

3. Create a point on an edge/line
To create a point: Click Point -> Select a reference edge/line by click on it -> change Offset ->OK
Note: Select Ratio & Real to see the difference, also check the Next End option

4. Create a point by using sketch
To create a point: Click Sketch Point -> Select a reference plane to sketch -> draw a point -> give the exact position to the point ->OK

5. Using Offset Coordinate System
To create a point: Click on Offset Coordinate System -> Select a reference Cartesian Coordinate System by click on it -> enter x, y, z values for the point you want to add into the pop out table ->OK

6. Exercise #1: Points, Curve & Sweep

7. Exercise #2: Point & Reference Pattern