1. Graphic Communication
Belmont Academy
Graphic Communication
Department of
Technical
Education

2. Department of Technological Education
Auxiliary Views
Auxiliary views are additional views that are used in orthographic projection.
Auxiliary views are normally used to view the true shape of a surface which does not face the front elevation, end elevation or plan at 90o.
Auxiliary views can be drawn as auxiliary elevations or auxiliary plans.
An auxiliary elevation uses the same heights as the other elevations and as with other elevations it is projected from the plan.
An auxiliary plan uses the same widths as the existing plan and similarly to the plan it is projected from the elevation.
An auxiliary view can be considered as looking at the object from different positions located somewhere between either the elevation and end elevation (for auxiliary elevations) or between the plan and end elevation (for auxiliary plans).

3. Department of Technological Education
Auxiliary Elevations
The block shown below shows a front elevation and an end elevation with two auxiliary elevations between them.
As can be seen the auxiliary elevation heights are the same as those on the front and end elevations.
It appears that the viewer is moving slowly round the block and viewing it from different viewing positions at ground level.

4. Department of Technological Education
Auxiliary Plans
The block shown below shows a plan and an end elevation with two auxiliary plans between them.
As can be seen the auxiliary plan widths are the same as those on the plan and end elevation.
It appears that the viewer is moving slowly round the block and viewing it from different view points in a radius from directly above the block around to ground level.

5. Department of Technological Education
Auxiliary Elevations
Unfortunately, because our object will be drawn on a piece of paper it will be difficult to ‘walk round the block’ to view it from different positions. We need to use some of the previously drawn views of the drawing to project our views.
What this means is that the views will be drawn in slightly different positions to that shown in the previous slide.
Each of the auxiliary elevations in the drawing will be projected from the plan, in the same way that the front elevation has been drawn (and occasionally the end elevation).
When drawing auxiliary elevations, the drawing will need to be drawn at the angle that you choose to view the block at.
For SQA purposes this will normally only be at 30o, 45o or 60o (the usual angles of the class set squares) although there is no reason why other angles could not be used.

6. Department of Technological Education
Auxiliary Elevations
The blocks shown here show the positions where auxiliary elevations might be positioned to show the front view or different elevations to the left hand side.
End Elevation
plan
Auxiliary Elevation
Auxiliary Elevation
Front Elevation

7. Department of Technological Education
Auxiliary Plans
A similar situation occurs when drawing auxiliary plans.
Each of the auxiliary plans in the drawing will be projected from the front elevation, in the same way that the plan was projected.
When drawing auxiliary plans, the drawing will again need to be drawn at the angle that you choose to view the block at.
For SQA purposes this will also normally only be at 30o, 45o or 60o.

8. Department of Technological Education
Auxiliary Plans
Plan
Auxiliary Plan
The blocks shown here show the positions where auxiliary plans might be positioned.
Similar views could also be drawn to the right hand side of the front elevation.
Auxiliary Plan
End Elevation
Front Elevation

9. TOTAL MARKS FOR QUESTION
Department of Technological Education
Auxiliary Projection
The following table shows when auxiliary views have been used in national qualifications exams in recent years.
YEAR
Subject
Paper
Type
TOTAL MARKS FOR QUESTION
1999
2000
2001
Baby Feeding Bottle
Higher
Auxiliary Elevation
Not specified
Approx 15
2002

10. PowerPoint Presentation produced by