1. The CMF Range

2. Indications
The OL1000 Bone Growth Stimulator is indicated for the non-invasive treatment of an established non-union acquired secondary to trauma, excluding vertebrae and all flat bones
SpinaLogic is indicated as an adjunct electromagnetic treatment to primary lumbar spinal fusion surgery for one or two levels.

3. OL1000 Product Overview External device Non-invasive
No direct skin contact required
Can be worn easily over a cast
30-minute daily treatment time
Large treatment area
Can be used with fixation devices
Simple, one-button operation
Easy to read LCD screen
Compliance monitor
Lightweight
Comfortable to wear
Portable
Powered by disposable batteries
Dual Coil and Single Coil options for treating range of fracture sites

4. Device Placement – OL1000/ Spinalogic
Use over cast or brace
Various sizes
Size of the device should be chosen so that the treatment site fits comfortably inside the device coil(s)
The treatment site should be placed near the centre of the device and the device secured in place
SpinaLogic should be placed precisely with the centre bar of the device over the incision site of the spinal fusion surgery
One size only
An extender belt can be ordered through Customer Service

5. Device Placement
When in place, the patient should be able to move around as necessary during the daily treatment
Because of the short, one-half hour per day treatment time, the patient should be encouraged to sit or rest comfortably during the treatment
The device must remain properly positioned for the treatment to be most effective

6. Operation & Display Icons – Initial Treatment
Apply the device, press and hold the “push button” until the device beeps. The LCD will display the “treatment record” icon until the device beeps
After the device beeps, the treatment record will be replaced by a “wait” icon
The device should then start to treat, counting down from thirty minutes, and display the “treatment” icon
At the end of the thirty-minute treatment the device will beep two times and display the “treatment complete” icon

7. Error Messages
Magnetic Interference Error – if the device comes into contact with another magnetic field it will stop
Replace Battery Error - if the batteries do not have enough charge to complete the day’s treatment, the device will not start the session and the battery icon will appear
Infrared Beam Error - If the patient removes their limb from the device during treatment, the beam will signal the device to stop treatment
Phone for Help Error - In the rare instance that the device cannot be fixed by the user and needs to be addressed by engineering, this icon will be displayed