1. Jul 12, 2010
07/12/10
Project: IEEE P Working Group for Wireless Personal Area Networks (WPANs)
Submission Title: TG4m Draft PHY Feedback
(TBD’s, Editorials, Other Comments)
Date Submitted: November 2012
Source: Clint Powell, Powell Wireless Commsulting, LLC
Contact: Clint Powell, Powell Wireless Commsulting, LLC
Voice: ,
Re: TG4m Draft PHY Feedback
Abstract: TG4m Draft Development
Purpose: TG4m Draft Development
Notice: This document has been prepared to assist the IEEE P It is offered as a basis for discussion and is not binding on the contributing individual(s) or organization(s). The material in this document is subject to change in form and content after further study. The contributor(s) reserve(s) the right to add, amend or withdraw material contained herein.
Release: The contributor acknowledges and accepts that this contribution becomes the property of IEEE and may be made publicly available by P
Slide 1
Slide 1
Page 1

2. TG4m Draft PHY TBD’s - due 12/7
Jul 12, 2010
07/12/10
TG4m Draft PHY TBD’s - due 12/7
TBD’s: blank power boosting values res. in doc. #
TBD: LTF blank table res. in doc. #
TBD: copy text from
TBD’s: Table blank STF and LTF duration res. in doc. # (see r02 for instructions)
TBD: blank ref. mod. block diag.
res. in doc. # (see r02 for instructions)
replace figure and text from doc below
res. in doc. # (see r02)
(HH) 1 - TBD: blank pad bit insertion section
res. in doc. # (need more work)
TBD: blank operating freq. range section
(HH) 1 - TBD: blank Tx pulse shaping
MAC/PHY - TVWS Ch. #’g: res. in doc. # (see r01 for instructions)
Slide 2
Slide 2
Page 2

3. TG4m Draft PHY Editorials
Jul 12, 2010
07/12/10
TG4m Draft PHY Editorials
Include ranging bit for all 3 PHY’s: doc. #
Fig. 114: - Change Scrambling to Whitening for PIB value, also in and in
: insert space before RF
& : change TX and RX to Tx and Rx
20.2 2nd paragraph: fix The
st sentence: change 127 sample to 128 samples
Table 137: put in dashed for all open cells
Table 137: remove ½ (rate) since all are ½
Fig. 119: change scrambling to whitening
Fig. 119: change If PHR to PHR
Fig. 119: remove Data-rate Frame Length & arrow
Table 139: remove ½ (rate) since all are ½
Slide 3
Slide 3
Page 3

4. TG4m Draft PHY Editorials (cont’d.)
Jul 12, 2010
07/12/10
TG4m Draft PHY Editorials (cont’d.)
: fix spacing around i below where
Fig. 122: change colors to B&W
Fig. 123: change colors to B&W, use Fig. from 15.4g
Fig. 137 & Fig. 131: fix xrefs and highlight
Fig. 124: remove Fig. 124 and ref. same Fig. in 2011 base doc. and remove all text in beneath Fig. 124
Fig. 125: correct blank cell
Table 142: add NB to figure title
Table 143: last column header needs rewording
st line: remove space after NB
Slide 4
Slide 4
Page 4

5. TG4m Draft PHY Other Comments
Jul 12, 2010
07/12/10
TG4m Draft PHY Other Comments
Comments to address once full draft is assembled.
bit order descriptions starting with
backup bands needed
: should figure and text be changed to represent actual dependence
: remove last line w.r.t.. “for the case when the PHR is 2-octet long 2-octet”
: change better to within
20.1.2, , : move to modulation section
Slide 5
Slide 5
Page 5