1. New Project: DOUBLE Layer Ring.

13. You may NOT just make a STRAIGHT BAND

14. You can drill into the top layer. And then cut away inside the design.
The TOP layer and center of BOTTOM layer.
The TWO LAYER RING project has um… 2 layers.
You can drill into the top layer.
And then cut away inside the design.

15. Remember to FILE & SAND both inside and outside EDGES of BOTH layers.
This is the back of
the bottom layer.
Can you drill and cut away
through BOTH layers?
The 2 layers will be soldered together
BEFORE making it round & into a ring.
YES!
But, you would do that
AFTER you SOLDER.
Basically it’s a smaller version of
the SHAPE with in a SHAPE project.

16. a full length DOUBLE BAND can only be done if the
TOP layer is cut away very THIN.
This is a very tricky thing to do.
Only attempt if you are willing to
WORK HARD.

17. Soldering a Full Length Double Band is almost impossible.
THIS is what usually happens.

18. Draw the BOTH layers TOGETHER.
Step ONE!

19. Draw the BOTTOM layer alone.
Step TWO!
Leave 1
GRID space
between

20. Draw the TOP layer alone.
Step THREE!
Leave 1
GRID space
between
Leave 1
GRID space
between

21. You will only design 3 rings instead of 10.

22. Messy. Scribbly. Poor Quality drawings are UNACCEPTABLE!
The quality of your work must be better (not worse)
than what you have previously done!

23. Lay a ruler along worksheet
at your ring size mark.
Draw a line across

24. Can NOT just make a STRAIGHT FLAT BAND

25. Can NOT just make a STRAIGHT FLAT BAND

26. Soldering
is just like the
“SHAPE
within a
SHAPE”
project.

27. Orange. Burnt. Scratches. Poor Quality Sanding is UNACCEPTABLE!
The quality of your work must be BETTER (not worse)
than what you have previously done!