1. slider qty (Each part) Client: Gadi Gate type: Model:
submarine gate
Model:
NO. of gate (Each part) /
Part name:
back
hanger
panel
Hot runner:
Part No:
Tool type:
2 plate mold
General thickness
Back:1.66MM
Hanger:1.68MM
Panel:1.37MM
slider qty (Each part)
Plastic material:
ABS
Lifter qty (Each part)
Part weight:
Back:40.1G
Hanger:7.3G
Panel:21.5G
Shrinkage:
1.005
Cavities:
1+1+1
DFM by:
James

2. panel
hanger
back

3. General layer

4. GATE SCHEME
back
Sub gate will to the ejector , please approve it。

5. Parting line
back
Parting line PL
Cavity
Core

6. cavity side mold structure
back
4 pcs insert pin, please approve！
these 4 surface please add 0.5 degree to avoid the part stick cavity！

7. Core side mold structure
back
And these place we will add 12 insert pin, for the air issue.

8. Part’s ejection back 5mm ejector 4 pcs 6mm ejector 5 pcs
Please approve it ！

9. Part’s thickness analysis
back OK

10. Part’s change in cavity/core side
back
These two place please add 3 degree in cavity side with reducing resin, for this place is shut off. Please approve it !
The red surface is cavity side, the blue color is core side , the green no draft , so please add 1 degree draft in core side with reducing resin.
The red surface is cavity side, the blue color is core side , the green no draft , so please add 1 degree draft in cavity side with reducing resin.

11. GATE SCHEME
panel
Sub gate for ejector, please approve it.

12. Parting line PL
Cavity
Core

13. Part’s ejection
panel
3.0mm ejector 16 pcs, please approve it.

14. Core side mold structure
panel
And these place we will add 12 insert pin, for the air issue.

15. Part’s thickness analysis
panel
OK ！

16. Part’s change in cavity/core side
panel
The red surface is cavity side, the blue color is core side , the green no draft , so please add 1 degree draft in cavity side and core side with reducing resin.

17. GATE SCHEME
hanger
Sub gate , please inform.

18. Parting line
hanger PL
Cavity
Core

19. hanger
Part’s ejection
4mm ejector 6 pcs, please approve.

20. Part’s thickness analysis
hanger
OK!

21. hanger
Part’s change in cavity/core side
The red surface is cavity side, the blue color is core side , the green no draft , so please add 1 degree draft in cavity side and core side with reducing resin.

22. hanger
These red surface, please reduce width each side 0.2MM to make kiss off with cavity side and core side.。
For the mold construction, please delete these two hole, for this place if do kiss off or shut off will very easy to break, so please add resin to delete the two side hole.

23. Thank you !!!