1. TSW3070 ARB WAVEFORM GENERATION
10/05/2017
Neeraj Gill

2. HARDWARE REQUIRED TSW3070EVM TSW1400EVM 6V power supply for TSW3070EVM
Mini USB cable for TSW1400EVM
USB A to B cable for TSW3070EVM
SMA cable for applying clock signal
SMA to BNC for connecting TSW3070EVM output to Oscope

3. Hardware setup USB A to B FOR TSW3070EVM 6V for TSW3070EVM
Output to Oscope
Clock signal 500MHz 6dBm
Mini usb for TSW1400EVM

4. DAC5682Z GUI LOAD
If board is connected correctly, status will indicate “Connected to DAC5682Z EVM!”
Click “Register Config”

5. DAC5682Z GUI Load Cont… Step 2 Step 1
Step 1 – click “Load Regs” under CDCM7005 tab and select “CDCM7005_4x.txt”
Step 2 – click “Load Regs” under DAC5682Z tab and select “DAC5682Z_4x.txt”

6. Setup DAC in HSDC Pro
Launch HSDC Pro, select Serial Number (DAC Capture Card)
Click OK

7. Setup DAC in HSDC Pro Select the “DAC5682Z” from the FW dropdown
Click OK to load the FW

8. Setup DAC in HSDC Pro
Go back to the DAC GUI and click the DLL reset radio button twice
The DLL light should turn from red to green

9. Setup DAC in HSDC Pro
Set “Data Rate” to “125M” and “DAC Option” to “2’s Complement”

10. Setup DAC in HSDC Pro Step 1 Step 2
Step 1 – Click “Load External Pattern File”
Step 2 – Select “DAC5682z customer pattern file.csv” and click OK

11. Setup DAC in HSDC Pro
Click Send to start waveform playback

12. DAC5682Z GUI Load Cont…
Go Back to DAC GUI and toggle software sync radio button

13. Output