1. Maintaining/Handling the Rubber PAD

2. 1. Handling the Rubber Pad
Incorrect Handling Method
If the Rubber is bent, the chip will not make contact with the PCB
Sharp tweezers or other sharp objects will damage the PAD, if handled improperly
Dirt or other dust particles may smudge the PAD, preventing contact with the chip

3. 1. Handling the Rubber Pad
Correct Handling Method
Handle the PAD only on its edges
Use coated gloves when handling the PAD

4. 2. Cleaning/Maintaining the Rubber PAD
Incorrect Maintenance/Cleaning Method
Using a brush of any form will leave dust or dirt on the Rubber PAD
Using a cotton swab with cleaning chemicals or even water will either damage or melt the Rubber PAD

5. 2. Cleaning/Maintaining the Rubber PAD
Correct Maintenance/Cleaning Method
Apply 3M SCOTCH MAGIC TAPE onto the area where the Chip and the Rubber PAD make contact to remove the dust/dirt
Recommended Model : 3M – MP - 18
Warning : Applying too much pressure onto the Rubber PAD may cause damage
10Cm
If using an AIR GUN, hold the gun approximately 10cm directly above the Rubber PAD
Using 3M SCOTCH MAGIC TAPE to remove the dust/dirt left on the Rubber PAD