1. Updated Power on Indicator Lamp from J1-76 to J2-07 in CM2350 Beta Wiring Diagram (B6.7/L9 Stage V) 5/30/2017

2. Project Scope
Change Summary: The beta wiring diagram for the B6.7 and L9 Stage V has updated the Power on Indicator Lamp from J1-76 (OEM 14-pin connector) to J2-07 (OEM 96-pin connector) on the CM2350. Background: The move of the Power On Indicator (POI) lamp pin location from the OEM 14-pin connector to the OEM J2 96-pin connector was made to simplify wiring for OEMs that will not be using the 14-pin connector at Stage V for the B6.7 and L9. Implementation Strategy and Date: Change will be implemented immediately (6/10/2017). Wiring diagram has already been changed and the software has been updated as well.

3. Change Summary (Using Graphics)
New location is pin 7 on the J2 OEM 96-pin connector.
Updated wiring diagram posted on GCE

4. CEB00515 Update to Mapping Guide
Power on Indicator (POI) Lamp 1. Overview: The Power on Indicator lamp gives visual indication of the state of the ECM. 2. Operation: The lamp will illuminate immediately when key ON is detected by the ECM and will stay illuminated until the ECM has completed its power down functions and has gone into sleep mode. Note that this feature can be used as notification that it is OK to remove power from the ECM. 3. Hardware: The Power on Indicator Lamp must meet the hardware requirements listed in Table 3-14.
Power On Indicator Location for B6.7 and L9 Stage V Only