1. Interfacing Motion Sensor with PIC Microcontroller
Jacaqueta Davis
Brock Dickinson
Michael Ledet

2. Objective
The objective of this project is to build is to use the knowledge we have gained to build a low cost motion detection device that will detect a human entering or exiting an area in order to create a better security system. This will be done, specifically, with a PIC microcontroller and an optical sensor.

3. Equipment PIC microcontroller Pinhole camera Networking interface
Additional basic electronic components
3D printer
Equipment

4. Basic Outline of Steps Involved
Order parts
Design circuit(s) on paper/software
Test all parts for compatibility
Build device
Develop code
Test and modify until perfect
Design and 3D print housing
Encase in housing and present

5. Potential Obstacles
There will be several unexpected troubleshooting and bug fixes, which we have dedicated time reserved.
There may be some difficulty linking the device to a network interface.
The lasers and receivers being used to detect the actual motion will need a lot of tuning as to not be too sensitive. Could cause system to be inadequate.
Alternative power source could prove to be a waste of time.

6. Deliverables

7. Deliverables

8. References https://www.adafruit.com/products/3202