1. Fiber Optics in High Voltage Transmission Environments
EE October 8, 2003
By: Jason Jones

2. My Reason for Choosing This Topic…
Find a Combination Between Fiber Optics and Power Engineering
This is looking at Fiber Optics in an alternative industry
Fig. 1
Fig. 2

3. Overview Basics of fiber optic and electrical transmission lines
Different uses of fiber optic cable in the transmission grid system
Employment options
Conclusion/summary

4. Can high voltage electricity be sent through fiber optics cable?
No conclusive evidence or research has shown that it is possible.
Only the use of converters, still not practical for long distances and high voltage.

5. Why use fiber optics with transmission lines?
Sensing and detection of electrical faults and failure(i.e –Supervisory Control and Data Acquisition Systems – S.C.A.D.A)
Can be used as a neutral or ground.
No EMC/EMI issues.
Communication between plants and substations
Extensive ROW (Right Of Way). The cost advantages of existing ROW makes utilities attractive line-leasing partners for many communications carriers.

6. Combination of Two Different Concepts
Fiber optic cables
Transmits light (photons)
Primarily for communications
Electric cables
Transmits electricity (electrons)
Primarily for powering electrical devices

7. Most commonly used Fiber Optic
All Dielectric Self Supporting (ADSS)
Wrap type
Optical Ground Wire (OPGW)

8. Details of ADSS Cables High fiber count Cheaper than OPGW
                                              
Details of ADSS Cables
High fiber count
Cheaper than OPGW
Installed along electrical transmission lines
Fig. 3

9. Details of the OPGW
OPGW is a composite wire which serves as a conventional overhead ground wire, with the added benefit of providing high-capacity and reliable fiber optic communication.
Fig. 4

10. Common Problems
Contamination – fertilizer, pesticides, exhaust, emissions, salt fog. Can only be solved on the design level, difficult because of high voltage design requirements
Space Potential – Electrical potential induced on fiber optic cables
Dry Band Arcing – Caused by the induced current during wet conditions

11. Space Potential Induced voltages can be in the tens of kV range.
Causes dry-band voltages and currents.
Causes huge and powerful electric fields.
Fig. 5

12. Dry Band Arcing
Caused by Space Potential and frequency of current in the cable.
Accurse in wet environments
Because of high induced voltage, current can be as low as 1.5mA.
Fig. 6

13. Employment Options Phillips Corning Fiber Planners
The Furukawa Electric Co.
Most power utility companies (i.e. National Grid, Alliant Energy, Duke Energy)

14. Conclusion/Summary Many research possibilities.
Very interesting employment.
Good chance of becoming an expert.
High Voltage – BE CAREFUL

15. References
“Electrical Design Parameters of All-Dielectric-Self-Supporting Fiber Optic Cable”, M.W. Touminen and R.G Olsen, IEEE Transactions on Power Delievery, Vol. 15, No. 3, July 2000
“Corona Caused Deterioration of ADSS Fiber-Optic Cable on High Voltage Lines”, G.G Karady, G. Besztercey, IEEE Transactions on Power Delievery, Vol. 15, No. 3, October 1999
“Sensor Design for Leakage Current Measurement on ADSS Fiber-Optic Cable”, G.G Karady, Q, Huang, M.R Hernandez, D. Srinivasan, IEEE 2001