1. Connect to a Controller & Update the OS

2. Component Check RS232 Cable -Supplied
MJ10-22-CS25 (RJ11 to DB9 converter)
-Supplied
MJ10-22-CS35 (USB to Serial converter)
-Additional

3. Check physical connections
Serial cable plugged into Port 1 on PLC
Jumpers are set for RS232 communication
Check part numbers
-Serial cable MJ10-22-CS25
-USB adapter MJ10-22-CS35
Port 1

4. USB programming cable
Some of our units can be programmed through a Mini-USB programming port
(If equipped, IE- V1210/V1040/V570)
No other hardware is required for USB connection
Note that COM port 1 function is suspended when the USB port is physically connected to the PC.

5. USB Driver USB port supports only OS and project download.
If requested to use Windows Update--do not accept this option; "Skip obtaining driver software from Windows Update".
Install only the driver provided by VisiLogic.
The USB cable must be disconnected during the installation.

6. Driver Check

7. Check software settings
Baud rate
- Standard baud
- Enhanced baud
Check Device Manager to ensure
-Port has no errors or warnings
(PC port is confirmed here)
Select “Get OPLC Info” button to check/confirm PLC

8. Check for O/S updates Updates automatically if required.
Requires connection to internet.

9. Has a new O/S been released?
You will receive one of 2 messages.
-Up to date.
-Updating files

10. Check & perform an O/S update

11. Updating an OS
The System Upgrade Wizard will guide you through the update of the OS

12. O/S Updating
A Progress Bar will show you the operations and current steps in progress

13. Finish Update of O/S
Successful OS Update

14. O/S Update Not Required