1. Installation and User Manual ver.1.0
Fiber Optic
Installation and User Manual ver.1.0
[to integrate with the user manual of DAS M32/M44]
MERCEDES NTG4 – NTG4.5
Multiconn Srl

2. Installation:
Activate the TV tuner with Diagnostic Mercedes System or through Engineering Menu. If TV tuner does not appear as option to set, DO NOT proceed with installation because the system does not support both the Original or aftermarket tuner. In this case it's possible to install the standard DAS receiver (NOT in fiber optic version) using the auxiliary video IN input and the remote control on equipment to command.
To install the DAS® receiver, refer to the specific user manual;
Pay attention on the connection of the power supply cable:
- RED wire (fig.3) must be DISCONNECTED.
The switch (ON/OFF) of the receiver will be controlled by the Fiber-Optic activity
- YELLOW wire (fig.1) must be connected to the +12V permanent/battery
- BLACK wire (fig.2) must be connected to the GND.
Power supply cable 3 1 2
Disconnect the original Fiber Optical cable (fig.4) from one of the original multimedia accessories inside the car (DVD, GPS, Amplifier, etc…) and match it directly to DAS® fiber optic female connector of the harness on equipment (fig.5). 4 4 5
MERCEDES 2
Multiconn Srl

3. Match the two other connectors of DAS® harness (fig
Match the two other connectors of DAS® harness (fig.6) respectively inside the original accessory (fig.7) and the other one inside DAS® receiver (fig.8). 7 7 8 8 6 5
Connect one of the 3 DAS® Video-OUT (fig.8) trough the adapter cables on equipment (fig.9) and the needed accessory (DCAB2FK-RCA in fig.9.1) with the Video-IN on the Head Unit (fig.10) by the dual green Fakra connector. 9 9
9.1 8
MERCEDES 3
Multiconn Srl

4. The back side of NTG4.5 Head Unit (fig.10).
Video-OUT
9.1
Video-IN
Video-IN
WARNING: if the Head Unit module has not the dual brown fakra connector, the car cannot accept an original or aftermarket TV tuner
MERCEDES 4
Multiconn Srl

5. Previous Channel (LEFT)
User Manual:
To enter in DAS TV tuner press VIDEO, then select TV tuner.
For the management of DAS receiver, use the arrow keys or the numeric keypad or the APS controller (joystick).
WARNING: For the basic settings such as color, contrast, brightness and format, please refer to the menu of the car and make sure that the format is congruent with the set menu on the DAS.
Comand APS controller
Right rotation = UP on remote control (dropdown menu)
Left rotation = Down on remote control (dropdown menu)
Down Joystick Scroll= OK/Menu
Right Joystick Scroll=
Right arrow on remote
Left Joystick Scroll=
Left arrow on remote
Previous Channel (LEFT)
Next Channel (RIGHT)
MERCEDES 5
Multiconn Srl

6. Remote Control Functions:
PRESS “CLEAR” TO SWITCH TO EMULATION MODE DIRECTIONAL BUTTONS ON THE REMOTE CONTROL (5=OK)
UP ARROW
MENU NAVIGATION - ZAPPING KEY
ON-OFF
TURNING ON/OFF
LEFT ARROW
MENU NAVIGATION - ZAPPING KEY
TV/AV1/AV2 SELECTION
CONFIGURATION MENU/OK
FUNCTIONS SET UP
RIGHT ARROW
MENU NAVIGATION - ZAPPING KEY
DAS MENU
TV/RADIO SELECTION
AND SEARCH SYSTEM
DOWN ARROW
MENU NAVIGATION - ZAPPING KEY
NUMBER KEYPAD
FOR CHANNEL PRE-SELECTION
VOLUME ADJUSTMENT
NUMBERS KEYPAD ARE EQUIVALENT TO REMOTE CONTROL
MERCEDES 6
Multiconn Srl

7. Via Selvetta, 7 - 21100 Varese – Italy
MULTICONN Srl
Via Selvetta, Varese – Italy
Tel
Fax