1. Project: IEEE P802.15 Working Group for Wireless Personal Area Networks
Submission Title: [Update on WCAI and FCC]
Date Submitted: [September 21, 2005]
Source: [Abbie Mathew] Company [NewLANS, Inc.]
Address [238 Littleton Road, Westford, MA , U.S.A.]
Voice: [(617) ],
Re: []
Abstract: []
Purpose: [Contribution to TG3c at September 2005 meeting in Garden Grove]
Notice: This document has been prepared to assist the IEEE P It is offered as a basis for discussion and is not binding on the contributing individual(s) or organization(s). The material in this document is subject to change in form and content after further study. The contributor(s) reserve(s) the right to add, amend or withdraw material contained herein.
Release: The contributor acknowledges and accepts that this contribution becomes the property of IEEE and may be made publicly available by P
c-update-wcai-and-fcc
c-update-wcai-and-fcc

2. Pertinent Documents
c-wcas-petition-to-fcc-amendment-to-part
c-co-existence-60-ghz-window-links-and-indoor-wlan-system
c-us-regulatory-items-in-60-ghz.ppt
c-comments-wca-petition
c-wca-chronology-july05-ppt
c-wca-60ghz-proposal-faqs-ppt
c-reply-to-comments-on-wca-petition-to-change-fcc-regulations-governing-the-unlicensed ghz-band-ppt
c-comments-wca-petition-to-change-fcc-regulations-governing-unlicensed ghz-band
c-ieee-letter-to-fcc-in-response-to-wcais-petition

3. Existing Rules in Part 15.255 Interference
Average power density ≤ 9 W/cm2 at 3 m
Translates to EIRP of 40 dBm in the far field
Peak power density ≤ 18 W/cm2 at 3 m
Translates to an EIRP of 43 dBm in the far field
Total peak transmitter power ≤ 500 mW
RF Radiation
Power density ≤ 1 mW/cm2 on antenna surface
Transmitter Identification
Within any 1 second interval of signal transmission, each transmitter must transmit a transmitter identification at least one

4. WCAI’s Case # 1
“..the near field for a high gain antenna typically extends beyond the 3-meter point, so there is little correlation between 3-meter PD measurements and the level of RF exposure near the antenna..”
WCAI’s Suggestion
EIRP = 82 dBm for Gain > 51 dBi
EIRP = [(2 * Gain) – 20] dBm for Gain ≤ 51 dBi

5. WCAI’s Case # 2
“…which imposes a transmitter identification (ID) requirement on indoor antennas used at GHz. The purpose of the rule is to permit users experiencing interference from indoor wireless LAN transmitters to more accurately identify where the interference is coming from. The rule thus applies to the transmitter ID requirement to transmission that emanate from inside a building. Unfortunately, there remains some confusion over whether the rule’s exclusion of outdoor antennas also excludes antennas located indoors but directed outside a window, commonly referred to as ‘window links.’ WCA believes it is reasonable to assume that the Commission did not intend to apply the rule to window links, since they effectively pose no greater interference risk than outdoor links.”
WCAI’s Suggestion
“…WCA therefore asks that the Commission eliminate any lingering uncertainty about this issue by modifying Section (i) to clarify that the rule’s transmitter ID requirement does not apply to indoor antennas that direct point-to-point transmissions outside through a window.”

6. Next Step
Gary Baldwin to give detailed update next week at the channel model conference call
Dial-in number: +(641)
Access code: #
Time
EST (US) 8 PM, Tuesday, September 27
PST (US) 5 PM, Tuesday, September 27