1. Proper Hand Tool Use and Safety
By Mr. Hvizdos
Technology Education

2. When drilling, the drill should be spinning in a _________ direction.
Forward
Opposite
Rip
Clockwise

3. Make sure the drill is spinning in a clockwise direction.

4. The rip saw is used to cut _________ the grain.
opposite
across
with
on top of

5. Rip Saw

6. The crosscut saw is used to cut ______ the grain.
opposite
across
with
on top of

7. Crosscut Saw

8. The tri-square and combination square measure what two angles?

9. A picture of the tri-square and combination square.

10. Always place your work piece in a ________, vise, or bench dog.
handle
hold machine
pneumatic press
clamp

11. Always place your work in a clamp, vise, or bench dog.

12. Always allow a drill bit to _____ after using it.
rasp
sharpen
cool
dry

13. Always allow drill bit to cool. They will be hot.

14. A ______ is a very rough file with big teeth.
rasp
triangle
rip
file card

15. Rasps are just files with very big teeth.
Click on the picture to watch a video!

16. Files have 4 main shapes…...

17. Files can be flat, half round, round, or triangular.

18. Always cut at a ____ angle when using the rip saw.
60 degree
45 degree
65 degree
40 degree

19. Always cut at a 60 degree angle when using the rip saw.

20. The ______ saw should be held at a 45 degree angle when cutting.
coping
rip
crosscut
file

21. The cross cut saw should be held at a 45 degree angle.

22. The _________ saw is used to cut curved shapes.
rip
crosscut
coping
rasp

23. The coping saw cuts curved shapes

24. The rip saw has ______ teeth than the crosscut saw.
larger and more
more
smaller
larger and less

25. Rip saws have bigger teeth
Crosscut Saw

26. Always identify the _______ before selecting a saw.
grain
friction
angle
type of wood

28. The teeth of a file are this shape.
circle
pulley
inclined plane
lever

29. The teeth of a file are inclined planes.

30. Never use a file without a ________.
rasp
across
push block
secure handle

31. Never use a file without a handle

32. Always cut on the ________ side of the line.
dark
waste
left
grain

33. Always cut on the waste side

34. The correct order for making a project is...
saw, file, sand.
file, saw, sand
drill, file, sand
saw, sand, file

35. The correct order is saw, file, sand.

36. Which picture shows the inch scale?

37. Please inform your teacher.
You are finished!!!
Please inform your teacher.