1. Injection mold specification
Client
FUJIXEROX
Model Name
FUJIXEROX(KAMUY)
Part Name
COVER_SIDE_R
Part No.
802B86480
DFM
Feitai Zhong

2. Integral Corrective Action List
ICAL
Page
OPEN POINTS
SOLUTIONS/ACTION
WHO 1 2 3 4
Plastics flow analysis
Please confirm?
Gas Assist Point 5
Parting _ line 6 7
Lifter 8
Slide 9
Cavity insert 10
Thin steel
Cancel the R? 11
Thin steel in the lifter
Reduce plastic? 12
Undercut & thin steel 13
Undercut
Add plastic? 14
Undercut & sharp steel
Add plastic & reduce plastic 15
Having no draft
Please put the draft?
I C A L
Integral Corrective Action List
1-Date of opening (all dates in2005)
2-Date of beginning of action
3-Date foreseen for validation
4-Date of validation (closing)
DFME Follow-up issue

3. Plastic Flow Analysis
Sub E.P Gates
Weld lines

4. Gas Assist Point
Gas Assist Point

5. Parting _ line
Cavity
Core

6. Parting _ line
Cavity
Core

7. Lifter A A
Detail A-A

8. Slide
Slide
Slide
Slide

9. Cavity insert Cavity insert Remark:
The cavity insert line will be recess into the part 0~0.05mm

10. Cancel this R for lifter
Modify 01
Lifter
Cancel this R for lifter

11. Modify 02 Lifter 7mm(3X) Reduce plastics
The steel in the lifter is only3.3mm, please increase the holes size to 7mm to make lifter stronger.

12. Modify 03_A A A B B C C D D
Please see the details in the next two pages.

13. Modify 03_B Changed Undercut Add plastic Add plastic reduce plastic
Original
Changed
Add plastic
Add plastic
Original
Undercut
reduce plastic

14. add plastic in the grid area
Modify 03_C
Original P/L
Sharp steel
Changed P/L
Proposal 1
Proposal 2
Original
Changed
Reduce plastics
in the grid area
add plastic in the grid area

15. Modify 04
All of the green surfaces are no draft, Please update the 3D data, otherwise, We will be
reduce plastics reference by mould release demand, OK?