1. CBR-D PPE Mask and Suit

2. MCU 2/P and 2A/P Masks Current standard issue for MSC
Unimolded silicone rubber face piece
Single flexible lens
Single filter (either side)
Two VoiceEmitters
Drinking tube
Nose cup for reduced fogging

3. MCU 2/P and 2A/P Masks If neither 2/P or 2A/P fits
crewmen, M40 may work better
Difference between 2/P and 2A/P:
2A/P can use MicEmitter inside the mask
2 Prongs in Nose Cup hook into Mic insert

4. MCU 2/P and 2A/P

5. CBRD Mask Must be donned in 9 seconds
Pre-fit masks to make donning faster
Pre-adjust forehead and temple straps to proper length
All that needs to be adjusted when donning is jaw straps

6. CBRD Masks At MOPP 2, mask is in carrier, worn on person
At MOPP 3, canister should be attached to mask
Canister should not be removed from packaging until this point
Each canister can only be used for 8 hours in a chemical environment
Only 15 minutes use with Blood Agents

7. CBRD Masks At MOPP 4, masks are donned STOP BREATHING and CLOSE EYES
Pull spider-strap over head
TIGHTEN jaw straps
Press on exhalation valve and blow out to PURGE the mask
Cover inlet on canister and suck in for a NEGATIVE PRESSURE TEST to ensure there are no leaks, lens should deform inward slightly

8. JSLIST/ACPG Suit
Protects against CBR for 24 hours in contaminated environment
Package should NOT be
opened until sufficient MOPP
level reached

9. JSLIST/ACPG Suits
Can be worn for 45 days in a normal working environment
Only serviceable for 120 days after package is opened
Can be washed 6 times
Once exposed to CBR, suit must be removed from service and incinerated
Suit cannot be decontaminated after exposure

10. JSLIST/ACPG Suit Gear Jacket w/ hood Pants w/ suspenders Boots
Cotton Liner Gloves
Rubber Outer Gloves

11. JSLIST/ACPG Suits Notes on Suits:
ACPG boots are worn over regular footwear
May not fit over all steel-toed boots
Suspenders cross on chest to prevent them from slipping off shoulders
Care must be taken to ensure no leaks along zippers/velcro, especially around the mask