Download presentation
Presentation is loading. Please wait.
1
Injection mold specification
Client Fuji Model Name Xerox Part Name Cover fuser Part No. 802b089810_k001 DFM Ming L.
2
Integral Corrective Action List
ICAL Page OPEN POINTS SOLUTIONS/ACTION WHO 1 2 3 4 Plastic Flow Analysis Pls confirm? Slide parting_line Pls confirm Slide parting_line? 5 Parting_line Pls confirm parting_line? 6 7 8 9 10 Sharp steel Changed the part,Pls confirm 11 Thin steel Reduce plastic,pls confirm? 12 No draft Reduce plastic? 13 Gas assistant location I C A L Integral Corrective Action List 1-Date of opening (all dates in2005) 2-Date of beginning of action 3-Date foreseen for validation 4-Date of validation (closing) DFME Follow-up issue
3
Plastic Flow Analysis side gate Weld line
4
Slide _ line Slide-B Slide-A Slide_line Slide_line Slide-A Slide-B
5
parting _ line Slide-A
6
parting _ line Slide-B
7
parting _ line
8
parting _ line Keep dim 17.7mm Keep dim 17.7mm Add plastic Add plastic
9
parting _ line This rib change like that.(2X)
Suggest to move this rib 2mm?(2X) The core steel too thin. 2mm
10
Question-1 Cancel R. This rib will be move..
Sharp steel. Suggest to cancel R. Cancel R. This rib will be move.. Sharp steel. Cancel C.
11
Question-2 Reduce plastic 1mm Reduce plastic 1mm each side.
Thin steel.
12
Question-3 All of the surfaces have no draft, draft from parting line, Pls update the 3D data, otherwise, We will reduce plastics for mould release.OK? Cancel R This location possibility for add material, when the mold design avoid the water line.
13
Gas assistant location
14
Gate location suggestion
Gate width:10~14mm gate located at one end to try to reduce the chance for deformation gate thickness = mm
Similar presentations
© 2025 SlidePlayer.com. Inc.
All rights reserved.