Presentation is loading. Please wait.

Presentation is loading. Please wait.

Model Reversion : A Client : Slider qty : 1 Model : Latte 2nd

Similar presentations


Presentation on theme: "Model Reversion : A Client : Slider qty : 1 Model : Latte 2nd"— Presentation transcript:

1 Model Reversion : A Client : Slider qty : 1 Model : Latte 2nd
Lifter qty : Part name : GUIDE-2NDINPUTTRAYRIGHT-MP Gate type : Side gate Part no.. : Cavities : 2 DFM by : Yao Lichun 2/3 Plate :

2 DFM follow-up issue. Integral Corrective Action List
ICAL ICAL 1 - Date of opening (all dates in 2005) 2 - Date of beginning of action 3.- Date foreseen for validation DFM follow-up issue Integral Corrective Action List 4 . Date of validation( closing) Page Open points Solutions / Action Who 1 2 3 4 P.3 Gate (mold flow) Waiting for confirmation. 07/09 P.4 Parting line P.5 Slider P.6 Suggestion Waiting for confirmation P.7 P.8 Draft angle P.9 P.10 P.11 Texture

3 Gate (mold flow) Side gate

4 The red line is part line
Parting line The red line is part line

5 Slider Slider

6 Suggestion These poles too thick, it will cause sink mark.
The red ribs are too thick, it will cause sink mark, suggest cut plastic and keep 1.4mm at ribs’ bottom, 1.2mm at ribs’ top.

7 Suggestion Thin steel here. 1.0

8 Draft angle There are will be steps.
We suggestion cut the red area plastics 1 degree for cavity and cut the blue shade plastics 0.5 degree for core

9 Add 5 degree on all red surfaces (reduce plastic).
Draft angle Add 5 degree on all red surfaces (reduce plastic).

10 Draft angle 1. For the other ribs, side surface in the cavity & slider, we will make a draft angle less than 2 degree (reduce plastic). 2. For the other ribs, side surface in the core, we will make a draft angle less than 1 degree (reduce plastic).

11 Texture Which area need texture? Please make enough draft angle for the texture.


Download ppt "Model Reversion : A Client : Slider qty : 1 Model : Latte 2nd"

Similar presentations


Ads by Google