1. Progress on the Bike!
Daniel O Connor

2. I got the Front Suspension and Bushings Made and Welded on.

4. I Designed my own steering bracket, manufactured it and mounted it.

5. I Began work on my Tan Cast Tank
I had to use 3 different pieces of tan cast glued together as the piece supplied was not big enough!

7. I am also adding a Tan Cast Fin/Splitter to the front of the bike!

9. I sourced a small 2 stroke engine from a strimmer
I sourced a small 2 stroke engine from a strimmer. I then stripped it and cut a corner off it so that you can see into the inner workings of the engine. This will be a valuable teaching resource in the future!

10. I designed and made my seat. This will be sprayed cherry red!

12. I made my brackets to mount my engine using the milling machine!

13. I made handle bar grips out of nylon!

16. I made and mounted brackets to mount the rear axel!

18. I made a former for my rear fender
I made a former for my rear fender. I then used this to make the rear fender out of 1.5mm sheet aluminium