1. Isolation and characterization of fluorophore-binding RNA aptamers
Leslie A. Holeman, Sara L. Robinson, Jack W. Szostak, Charles Wilson 
Folding and Design 
Volume 3, Issue 6, Pages (November 1998)
DOI: /S (98)
Copyright © 1998 Elsevier Ltd Terms and Conditions

2. Figure 1
SRB-1 and SRB-2 sequences. Doped pools based on the sequences of the alkaline-hydrolysis-mapped domains of SRB-1 and SRB-2 were prepared in the form shown on the top line of each panel. Following six rounds of re-selection, sulforhodamine-binding sequences dominated each pool, at which point individual clones were isolated and sequenced. Dashes indicate conservation of the original SRB-1 or SRB-2 sequence. (a) Multiple isolates of the same progenitor molecule were obtained from the SRB-1 re-selected pool, indicating that relatively few mutants in the doped pool were capable of binding. (b) Analysis of the re-selected clones from the SRB-2-derived pool clearly show conservation of a structural motif. The top line indicates elements that make up the structure shown in Figure 2; 1, 2 and 3 indicate helices 1, 2 and 3, respectively, in SRB-2.
Folding and Design 1998 3, DOI: ( /S (98) )
Copyright © 1998 Elsevier Ltd Terms and Conditions

3. Figure 2
(a) Secondary structural model of SRB-2, inferred from analysis of the re-selected sequences. The shaded region corresponds to highly conserved nucleotides. Variation from the consensus sequence in the joining and loop regions is indicated. Arrowheads mark the boundaries of the minimal aptamer defined by alkaline hydrolysis. (b) A minimal aptamer based on the proposed structure was prepared and assayed for binding to SR agarose. More than 75% of applied RNA bound to the column, an increase of approximately 25% over that obtained for the original SRB-2 aptamer. (c) A minimal aptamer containing all of the highly conserved nucleotides but lacking the poorly conserved P2 region was prepared and assayed for binding. Less than 2% of applied RNA bound to the SR agarose column.
Folding and Design 1998 3, DOI: ( /S (98) )
Copyright © 1998 Elsevier Ltd Terms and Conditions

4. Figure 3
Specificity of binding to ligand analogs. Minimal SRB-2 aptamer was applied to SR agarose, washed with ten column volumes of selection buffer, and subsequently eluted with selection buffer containing 5 mM SR, 5 mM SR analog, or no additive. The amount of RNA eluted by each elution protocol was determined by scintillation counting and normalized to that specifically eluted by SR. Analogs were classified as moderate-to-good competitors (25–100% elution), weak competitors (5–25% elution), or very poor competitors (0–5% elution).
Folding and Design 1998 3, DOI: ( /S (98) )
Copyright © 1998 Elsevier Ltd Terms and Conditions

5. Figure 4
Phosphorothioate mapping of the substrate-binding site. (a) Structure of 5-iodoacetamidofluorescein (IAF), used as a reactive ligand analog. (b) Results of IAF reaction with phosphorothioate RNA. RNA with ∼10% of adenosines (approximately one site/molecule) substituted by adenosine phosphorothioate was incubated with or without (–) IAF and induced to cleave at alkylation sites as described in the Materials and methods section. Unsubstituted RNA was treated in parallel with IAF or subjected to alkaline hydrolysis (AH). The three sites of preferred reaction are numbered 1–3. (c) The sites of preferred reaction mapped onto the secondary structure of the SRB-2 aptamer.
Folding and Design 1998 3, DOI: ( /S (98) )
Copyright © 1998 Elsevier Ltd Terms and Conditions

6. Figure 5
Fluorescein aptamer specificity and double labeling. (a) Sequence of FB-1, an aptamer selected for binding to fluorescein. (b) Comparison of sulforhodamine aptamer (minimal SRB-2) and fluorescein aptamer (FB-1) binding to either sulforhodamine (SR) agarose or fluorescein (F) agarose. Binding was assayed as described in the Materials and methods section. (c) Beads labeled separately with biotinylated SRB-2 aptamer or FB-1 aptamer were mixed together and co-incubated with sulforhodamine and fluorescein. BF, bright field view of the streptavidin–agarose beads. F, HQ–FITC–LP filter, which yields fluorescent signal with both fluorescein-based and (to a lesser extent) rhodamine-based fluorophores. R, Texas-red–LP filter, which yields fluorescent signal exclusively with rhodamine derivatives. F/R, double exposure with both filter blocks.
Folding and Design 1998 3, DOI: ( /S (98) )
Copyright © 1998 Elsevier Ltd Terms and Conditions