1. QUADCOPTER PRODUCTION PLAN

2. OUTILLAGE
Hex wrench 2.5 mm
Open-end spanner 5.5 mm
Hex wrench 2 mm

3. -Set the arm supports without screwing it on the x500mm Big Arm

4. -Set x500mm Big Arm and his Arm supports on the Uper shell
Upper Shell (10)
205 mm
205 mm
80 mm

5. -Set the arm supports on the upper shell without screwing them.
-The screws not screwed will be used to fix the attachment pillar.
Arm Support (8)

6. M3 Nut (1)
-Block the 245 little arm in the arm support that have the same centering as the x500mm Big Arm.
M3x25 Screw
(3)

7. -Set the attachment pillar on the arm supports.
M3 attachment pillar (7)
M3 attachment pillar (7)

8. -Screw the lower shell on the M3 attachment pillar with the M3 screws.
M3 Nut (1)

9. Assembling of the landing gear:
Set the 2 landing gears against the M3 Spacer landing gear then fix it with the 2 M3x5 Screw.
At the same time place the large partie of each landing gear on the arm support and screw it with the 2 M3x25 screw and the M3 Nut.
Landing gear
M3 Nut (1)
M3x25 Screw
(3)
Arm Support (8)
M3x5 Screw (5)
M3 Spacer Landing gear (6)
Assembling landing gear

10. -Fix the 4 landing gears on the 4 arms.
They need to be fixed at the extremity of the arms.
Arm
Landing gear

11. Frame of the drone assembled: