Download presentation
Presentation is loading. Please wait.
Published byFernando Brumagin Modified over 10 years ago
1
DS1000B-RM/ DS1500B-RM Battery Replacement Procedure
2
1.Pull off the front panel.
3
2. Remove the battery retaining plate. 3. Pull out the battery cartridge.
4
4. Remove the four screws from the battery cartridge and open it. There are three batteries in it.
5
5. Disconnect the black wire connecting the battery to the UPS. 6.Disconnect the red wire connecting the battery to the UPS. Then remove the other wires connecting the batteries.
6
7.Install the new batteries. With the battery terminals facing you, make sure that the main red wire is connected to the red terminal of battery #1 and the main black wire is connected to the black terminal of battery #3. 8.Complete the installation by connecting the two other wires between battery #1 and #2 and between #2 and #3 as shown.
7
9. Close the batteries cartridge and tighten the four screws. 10.Slide the battery cartridge into the UPS. 11.Reinstall the battery retaining plate. 12.Put back the front panel.
Similar presentations
© 2025 SlidePlayer.com. Inc.
All rights reserved.