1. Electric Current, Resistance, Ohm’s Law, Power, & Simple Circuit
Electromagnetism
Electric Current, Resistance, Ohm’s Law, Power, & Simple Circuit
MARLON FLORES SACEDON

2. Electric Current What is an electric current?
An electric current is a flow of electric charge. In electric circuits this charge is often carried by moving electrons in a wire. It can also be carried by ions in an electrolyte, or by both ions and electrons such as in a plasma.
For a steady flow of charge through a surface, the current I (in amperes) can be calculated with the following equation:
𝐼= 𝑄 𝑡
where Q is the electric charge transferred through the surface over a time t. If Q and t are measured in coulombs and seconds respectively, I is in amperes.
The SI unit for measuring an electric current is the ampere, which is the flow of electric charge across a surface at the rate of one coulomb per second. Electric current is measured using a device called an ammeter
Andre Marie Ampere
𝐼 → 𝑐𝑜𝑢𝑙𝑜𝑚𝑏 𝑠𝑒𝑐𝑜𝑛𝑑 = 𝐶 𝑠 = 𝑎𝑚𝑝= 𝐴

3. Electric Current Two kinds of electric current?
Direct current (DC) is the unidirectional flow of electric charge. Direct current is produced by sources such as batteries, thermocouples, solar cells, and commutator-type electric machines of the dynamo type. Direct current may flow in a conductor such as a wire, but can also flow through semiconductors, insulators, or even through a vacuum as in electron or ion beams. The electric charge flows in a constant direction, distinguishing it from alternating current (AC). A term formerly used for direct current was galvanic current.
Alternating current (AC, also ac), the movement of electric charge periodically reverses direction. In direct current (DC, also dc), the flow of electric charge is only in one direction.
AC is the form of electric power delivered to businesses and residences. The usual waveform of an AC power circuit is a sine wave. Certain applications use different waveforms, such as triangular or square waves. Audio and radio signals carried on electrical wires are also examples of alternating current. An important goal in these applications is recovery of information encoded (or modulated) onto the AC signal.

4. Resistor
A device having a designed resistance to the passage of an electric current.

5. Resistor

6. Ohm’s law 𝐼= 𝑉 𝑅 R= 𝑉 𝐼 Where: V is voltage (v)
I is electric current (A)
R is resistance (Ω)

7. Electric power 𝐼= 𝑑𝑄 𝑑𝑡 𝑑𝑄=𝐼 𝑑𝑡 𝑉 𝑎𝑏 𝑑𝑄= 𝑉 𝑎𝑏 𝐼 𝑑𝑡 𝑊 𝑎𝑏 = 𝑉 𝑎𝑏 𝐼 𝑑𝑡
𝑊 𝑎𝑏 𝑑𝑡 = 𝑉 𝑎𝑏 𝐼

8. Simple circuit With internal resistance r….
Without internal resistance r….

9. Simple circuit

10. Simple circuit
Problem 1: Figure shows a source (a battery) with emf 𝜀=12𝑉 and internal resistance 𝑟=2Ω . (For comparison, the internal resistance of a commercial 12V lead storage battery is only a few thousandths of an ohm.) The wires to the left of a and to the right of the ammeter A are not connected to anything. Determine the respective readings 𝑉𝑎𝑏 and I of the idealized voltmeter 𝑉 and the idealized ammeter 𝐴.

11. Simple circuit
Problem 2 Figure shows a source (a battery) with emf 𝜀=12𝑉 and internal resistance 𝑟=2Ω . (For comparison, the internal resistance of a commercial 12V lead storage battery is only a few thousandths of an ohm.) The wires to the left of a and to the right of the ammeter A are not connected to anything. Determine the respective readings 𝑉𝑎𝑏 and I of the idealized voltmeter 𝑉 and the idealized ammeter 𝐴.
By adding 4Ω resistor?

12. Application: Leyte Electric Cooperative (LEYECO) provides supply voltage approximately 220V to the consumers. What must be the approximate resistance value of a 10 watt LED bulb connected parallel to this source voltage?

13. Problem

18. eNd