1. Solidworks Computer-Aided Drafting Program LESSON 7- Angle Bracket
Presenter
Billy Fowler

2. Lesson 6- Angle Bracket 2D Sketch to 3D Extrude View Extrude Cut , Fillet Insert Hole on a reference point/line

3. Sketch lines in an “L” pattern with set dimension of 4” x 3”

4. Insert horizontal lines with set dimension of 0.5”

5. Sketch vertical and horizontal lines in accordance of already existing lines

6. Extrude to a Depth of 2”

7. Rotate Part until you can see the following faces of part

8. Fillet both Edge 1 and Edge 2 @ 1 inch

9. Insert the following Reference lines on the following face

10. Insert a Hole at the vertex of crossing reference lines, set hole settings at 0.5” depth and 1” diameter
Insert, Features, Hole, simple

11. Rotate part so you can focus on the opposing face
Fillet the other edges of part at 0.25

12. Insert the following reference line

13. Rotate and zoom on the edge of face, apply the following lines, use smart dimension to set the following spacing and dimension

15. Apply three point arc connecting the two sketched lines, set radius at 0.25

17. Extrude cut the following sketch at 0.5”

18. Rotate and Zoom in on the following edges

19. Fillet the following Edges @ 0.25”