1. Starter On page 8 of your book answer the following questions.
What is one piece of jewelry you have always wanted to learn to make.
Do you know someone that loves jewelry? What size jewelry are they?
Draw a pair of earrings with a design of your choice.

2. Symbol Pendants & saw blades
Jewelry
Symbol Pendants & saw blades

3. Agenda for today Review what we did last time.
Demonstration on how to stamp, drill, and saw your sheet metal.
Check off putting in saw blade
Designs are due on sheet metal and beginning to cut today.
If you do not have the sheet metal with a design on it by the end of class today you will be getting a travel pass as your ticket out of class.

4. Last time
We reviewed our safety test and made sure everyone had it correct.
Many of you got your designs done, but only a few began cutting out with x-acto knives.
If you were not here last time you will need to get caught up by coming after school.

5. How to saw your sheet metal How to drill your sheet metal
Demonstration
How to saw your sheet metal
How to drill your sheet metal

6. What should you be doing?
You should be cutting out your design from the paper and gluing it to the sheet metal.
Once done you should begin sawing your sheet metal.
If you are behind let me know what I can do to help.

7. Clean up…
Make sure you are putting all supplies away where they belong.
None of the supplies belong in your box.
Make sure you throw away broken saw blades.
Last time a students left supplies out, boxes out, sketch books out, and papers.
If this happens again I will have to have us all spend a class period learning to clean properly than clean the entire class room.
Please clean up and put things away where they belong every time.

8. Exit Questions
What is something that you are concerned about in this class?
What is a project that you are looking forward to?
If you didn’t start sawing today what should you do to get caught up?