Presentation is loading. Please wait.

Presentation is loading. Please wait.

5/29/2019 Course Objectives This course teaches analog integrated design using CMOS Technology Analog Circuit Design.

Published byScot Matthews Modified over 5 years ago

Similar presentations

Presentation on theme: "5/29/2019 Course Objectives This course teaches analog integrated design using CMOS Technology Analog Circuit Design."— Presentation transcript:

1 5/29/2019 Course Objectives This course teaches analog integrated design using CMOS Technology Analog Circuit Design

2 5/29/2019 Analog Circuit Design

3 Course Prerequisites Circuit Analysis Techniques
5/29/2019 Course Prerequisites Circuit Analysis Techniques Mesh and loop equations Superposition, Thevenin and Norton’s equivalent Circuit Basic understanding of electronics Active and passive components Large and small signal models Frequency response Integrated Circuit Technology Circuitos I,II Electrónica I,II Analog Circuit Design

4 5/29/2019 Course Philosophy Think before design! Analog Circuit Design

5 The Analog IC Design Process
5/29/2019 The Analog IC Design Process Electrical Design Simulation Physical Design Fabrication Testing Product Development Analog Circuit Design

6 What is Electrical Design?
5/29/2019 What is Electrical Design? Electrical design is the process of going from the specifications to a solution. Analog Circuit Design

7 What is Physical Design?
5/29/2019 What is Physical Design? Physical design is the process of representing the electrical design in a layout. The layout is then used to create the actual three dimensional circuit through fabrication. Analog Circuit Design

8 Packaging? What is Test Design?
5/29/2019 Packaging? Packaging provides the electrical and mechanical connection between the integrated circuit and the outside world. What is Test Design? Test design is the process of coordinating, planning and implementing the measurement of the analog integrated circuit performance. Objective: To compare experimental performance with specifications and/or simulations results. Analog Circuit Design

9 Modern CMOS Technology
5/29/2019 Modern CMOS Technology * For this course we will be using an n-well process, hence the bulk terminals of all nMOS transistors are connected to the lowest potential.. Analog Circuit Design

10 Metal Oxide Semiconductor FET (MOSFET)
5/29/2019 Metal Oxide Semiconductor FET (MOSFET) Symbol iD vs vGS Behavior iD vs vDS Behavior Analog Circuit Design

11 MOS Transistor Regions of Operation Saturation Ohmic Subthreshold
5/29/2019 MOS Transistor Regions of Operation Saturation Ohmic Subthreshold 𝑉 𝑂𝑉 = 𝑉 𝐺𝑆 - 𝑉 𝑡ℎ Analog Circuit Design

12 MOS Transistor Large Signal Equivalent Circuit: Saturation Region
5/29/2019 MOS Transistor Large Signal Equivalent Circuit: Saturation Region Analog Circuit Design

13 MOS Transistor Small Signal Behavior Small-Signal Equivalent Circuit
5/29/2019 MOS Transistor Small Signal Behavior Small-Signal Behavior Bias Point Small-Signal Equivalent Circuit Analog Circuit Design

Download ppt "5/29/2019 Course Objectives This course teaches analog integrated design using CMOS Technology Analog Circuit Design."

Similar presentations

Lecture Metal-Oxide-Semiconductor (MOS) Field-Effect Transistors (FET) MOSFET Introduction 1.

Lecture Metal-Oxide-Semiconductor (MOS) Field-Effect Transistors (FET) MOSFET Introduction 1.
Transistors Three-terminal devices with three doped silicon regions and two P-N junctions versus a diode with two doped regions and one P-N junction Two.

Transistors Three-terminal devices with three doped silicon regions and two P-N junctions versus a diode with two doped regions and one P-N junction Two.
Microelectronic Devices and Circuits Mozafar Bag-Mohammadi Ilam University.

Microelectronic Devices and Circuits Mozafar Bag-Mohammadi Ilam University.
EE 221 Review 2 Nodal and Mesh Analysis Superposition Source transformation Thevenin and Norton equivalent Operational Amplifier.

EE 221 Review 2 Nodal and Mesh Analysis Superposition Source transformation Thevenin and Norton equivalent Operational Amplifier.
BASIC SEMICONDUCTOR ELECTRONIC CIRCUITS Introduction of two basic electronic elements: diode and transistor LEARNING GOALS Diodes structure and four modeling.

BASIC SEMICONDUCTOR ELECTRONIC CIRCUITS Introduction of two basic electronic elements: diode and transistor LEARNING GOALS Diodes structure and four modeling.
Introduction to CMOS VLSI Design Lecture 0: Introduction.

Introduction to CMOS VLSI Design Lecture 0: Introduction.
The Devices: MOS Transistor

The Devices: MOS Transistor
Chapter 6 The Field Effect Transistor

Chapter 6 The Field Effect Transistor
Transistors Student Lecture by: Giangiacomo Groppi Joel Cassell

Transistors Student Lecture by: Giangiacomo Groppi Joel Cassell
MAHATMA PHULE A.S.C. COLLEGE, PANVEL Field Effect Transistor

MAHATMA PHULE A.S.C. COLLEGE, PANVEL Field Effect Transistor
Government Engineering College,

Government Engineering College,
Chapter 3 Resistive Network Analysis Electrical Engineering/GIEE

Chapter 3 Resistive Network Analysis Electrical Engineering/GIEE
Field Effect Transistors

Field Effect Transistors
BJT transistors.

BJT transistors.
Chapter 3 Fabrication, Layout, and Simulation.

Chapter 3 Fabrication, Layout, and Simulation.
Chapter 2 MOS Transistors.

Chapter 2 MOS Transistors.
MOSFET The MOSFET (Metal Oxide Semiconductor Field Effect Transistor) transistor is a semiconductor device which is widely used for switching and amplifying.

MOSFET The MOSFET (Metal Oxide Semiconductor Field Effect Transistor) transistor is a semiconductor device which is widely used for switching and amplifying.
MOS Field-Effect Transistors (MOSFETs)

MOS Field-Effect Transistors (MOSFETs)
FIELD EFFECT TRANSISTOR

FIELD EFFECT TRANSISTOR
Other Transistor Topologies

Other Transistor Topologies

Similar presentations

Ads by Google