Presentation is loading. Please wait.

Presentation is loading. Please wait.

SMPS POWER PLANT SMR 48V/25A SALIENT FEATURES

Similar presentations


Presentation on theme: "SMPS POWER PLANT SMR 48V/25A SALIENT FEATURES"— Presentation transcript:

1 SMPS POWER PLANT SMR 48V/25A SALIENT FEATURES
PUNCOM offers SMR-48V/25A , a switch mode rectifier module, designed to provide up to 25A of output current to a 48V nominal system for telecom, datacom, industrial and IT applications. It converts V AC input power at 50 or 60Hz into a highly regulated, filtered, low noise and isolated 48V DC output. The unit is designed for N+1 redundant configurations. Up to eight rectifier modules can fit in a single 19” rack to provide 200A of current in N configuration and 175A of current in N+1 configuration. One control and supervisory unit (MiniCSU) is used for configuring the system. The system can also be monitored and controlled remotely through Remote Monitoring Unit. The rectifier has been designed with a “plug-and-play” feature i.e. when a rectifier module is plugged into a live system the relevant system parameters are automatically downloaded from the MiniCSU, making rectifier replacement a completely hands-off operation. The unit is fully hot pluggable. There is provision of monitoring key parameters of battery for checking the health of battery using Battery Health Check Module. Parameters like cell temperature, cell voltage, cell conductance etc can be measured. SMPS Power Plant is type approved to TSEC & RDSO specifications SALIENT FEATURES Hot Pluggable. 200A in a 19” rack in N configuration and 175A in N+1 configuration Wide range of AC input, V provides protection from power disturbances and in combination with high interrupting capacity fast acting fuses translates into better reliability Battery temperature compensation Compliant to IEC & CISPR 22 specs for EMI/EMC Optional RS 232,RS 485,10Base T Ethernet and modem interfaces Fully menu driven with user friendly navigator push buttons menu Type approved to TSEC & RDSO Specs Active power factor correction > 0.95. Very High power density > 4.0W/Inch3. High efficiency: better than 90% at > 50% load. Plug and play capability without any adjustments. Digital active current sharing Password protection against unauthorized parameters change

2 Punjab Communications Limited
SMR 48V/25A SPECIFICATIONS INPUT CHARACTERISTICS 220VAC 90-300VAC 17A RMS at 90VAC 9A RMS at 220VAC 45-66Hz >0.95 at 40%-100% load Current THD<10% at > 50% load Voltage THD <10% at > 50% load Better than 90% at full load <8A peak at nominal mains voltage Ramp up time 8 seconds to full load HRC input fuse for input Live Over voltage shutdown at 300VAC Under voltage shutdown at 90VAC 1500VAC input to chassis for one minute Protection Reverse Polarity Over voltage Over current Over temperature Voltage Withstand test Fuse at output protects against reverse polarity Only faulty unit shuts down Can sustain short Circuit indefinitely Gradual reduction of power limit if heat sink temp exceeds preset limit 1500VAC output to chassis for one minute Voltage Nominal Rated voltage range (Full Load) Frequency Power Factor Harmonic Distortion Efficiency Inrush current Soft Start Protection Voltage withstand test Indicators Controls/Adjustments (Via MiniCSU) Status normal-green LED Minor alarm-Yellow LED Major alarm-Red LED Float/equalize voltage Current limit HVSD level and reset Equalize mode Individual remote shutdown OUTPUT CHARACTERISTICS Voltage Float Equalize Current Limit Power Static Regulation Line Load Dynamic Regulation Noise Load Sharing MECHANICAL 48-58V V 5A to 26A 1400W Better than ±0.02% Voltage drops by 0.56V ±0.03V from zero to 25A for stand alone & better than ± 0.05% for MiniCSU controlled unit ±5% for 25% to 100% step load ±1% of final value within 10msec of step change ±5% step change in AC input voltage VAC <2mV RMS psophometric weighted <10mV RMS (10KHz-100MHz) <100mV peak to peak(10KHz-100MHz) Better than ±5% of full scale with active current sharing from MiniCSU Dimensions Rack W x H x D Module W x H x D Min CSU W x H x D Weight SMR/Minicsu 600mm x 1465mm x 595mm (max.) 87mm x 266mm x 320mm 176mm x 44mm x 266mm <6Kg/1.3Kg ENVIRONMENTAL -25oC to +50oC -40oC to +70oC 0 to 95% RH non-condensing Forced Cooling Derate max ambient temperature by 4oC per 1000m above sea level to 3000m Meets IEC specs for EMC immunity and CISPR 22 class B for EMC emissions Operating range Storage Humidity Cooling Altitude EMI/EMC Specifications subject to change without prior notice. 110708 Punjab Communications Limited B-91, Phase VIII, Industrial Area, Mohali, Punjab India Phone: , Fax: Visit us at:


Download ppt "SMPS POWER PLANT SMR 48V/25A SALIENT FEATURES"

Similar presentations


Ads by Google