1. SAVI SCOUT® System Setup

2. System Setup: Components
Guide cord receptacle
Volume indicator
Guide
Multi-use

3. System Setup: Console Place console on top of cart or other equipment
Position console to accommodate 5 ft. Handpiece/Guide cable
(i.e. side of OR table vs. foot of OR table)
Attach power cord to console and plug into outlet
Power on/off
switch
Power cord
receptacle
Fuse Drawer

4. Handpiece Options Handpiece available as:
Disposable Single-use, HPSU-01
Multi-use Guide, SG-01

5. Single-use Handpiece Packaging
Box label
Outer box
Top
Side
CATALOG NO. HPSU-01
Double pouch
Inner backer card
Handpiece Test Card
DO NOT DISCARD
Used to verify function prior to surgical use

6. System Setup: Single-use Handpiece
Remove Handpiece and Handpiece test card from packaging & transfer into sterile field
Double pouch package
Place Handpiece and Handpiece test card in field at convenient location for surgeon

7. System Setup: Single-use Handpiece
Attach Handpiece to console
Align arrow on Handpiece connector with white dot on console port
Press until secure connection made between Handpiece and console
Handpiece receptacle connector
Alignment notch
Alignment arrow

8. Multi-use Guide Overview
Multiple-use
Model #: SG-01
Ships with storage case
Guide has test card attached to cable near connector (non-sterile)
Guide test should be performed prior to inserting into sterile sheath
For use with SCOUT Guide Sheath – SH-01

9. Custom Sheath Packaging

10. Custom Sheath Do not use rubber bands.
Use provided Steri-Strips to secure sheath in position 10

11. System Setup: Multi-use Guide
Attach Guide to console
Align arrow on Guide connector with white dot on console port
Press until secure connection made between Guide and console
Guide cord receptacle
Alignment notch
Alignment arrow

12. System Setup: Power up Turn on ‘Power’ switch on back of console
Visual display and buttons on front of console will activate
‘INITIALIZING’ message appears during warm up
‘SYSTEM READY’ message appears when ready (~30sec)

13. System Setup: Handpiece/Guide Test
Press ‘START/STOP’ button to activate Handpiece/Guide
“LOCALIZATION MODE” appears
Place Handpiece/Guide on Test Card as indicated
Positive test – audible clicking, distance readout visible
Negative test – no sound, no distance measurement readout
Replace with new handpiece
Press ‘START/STOP’ to deactivate Handpiece/Guide until surgeon ready to begin case
System is now ready to use

14. Console Display Messages
Appears when console power switched on
~30 seconds to ‘SYSTEM READY’ mode
Appears when system ready for use
‘1’ - normal state, display will not show ‘0’
Mode for when Handpiece/Guide not in use
Appears when START/STOP button pressed
Handpiece/Guide active and ready to detect reflector
Distance measurement will appear once a reflector is detected
Appears when issue with Handpiece/Guide or cable connection
Confirm Handpiece/Guide fully inserted into receptacle
Power off/on
If message persists, replace Handpiece/Guide
Two most common modes
Appears when Guide/Handpiece is damaged or Single- Use Handpiece has expired
Turn console offf
Replace handpiece
NOTE: For single-use handpiece, during detection, once distance readout is visible, handpiece will be active for 2 hours before expiring

15. Post-Procedure System shut down Press START/STOP button
Turn off power switch
Disconnect handpiece or Guide
Unplug power cord if console will be moved or stored
Cleaning
Wipe all console surfaces, including handpiece receptacles, and power cord with a mild cleaning solution or disinfectant and a damp cloth