1. Unity Application Generator
How to develop the Physical Model

2. Steps
After performing step mentioned in document “2-Start developing a project.ppt”, right click on SITE
This window will appear:

3. Steps Write proper name along with description and click OK:
An AREA will be available in Physical Model:
Right click on AREA1 and click on New Process Cell:
This screen will appear, give proper name /description and then click on OK.

4. Steps A process cell will be available in the Physical Model:
Right click on PROCESS1 and click on New Unit:
This screen will appear, give proper name /description and then click on OK.

5. Steps A process cell will be available in the Physical Model:
Right click on PROCESS1 and click on New Unit:
This screen will appear, give proper name /description and then click on OK.

6. Steps A unit will be available in the Physical Model:
Right click on Unit1 and click on New Equipment Module:

7. Steps This screen will appear:
Key in proper NAME, description but leave PLC NAME and HMIControl Domain blank. NOTE: PLC section name will be given by UAG as default
Like this:
Click OK

8. Steps
At the end of this step, there should be a Physical Model available in UAG like this: