1. PREPARING
C – SILICONES

2. PREPARING SILOFLEX PLUS
Easy processing
Easy dosage, short mixing time, easy check of
homogeneously mixed material with colour contrast catalyst

3. PREPARING SILOFLEX PLUS PUTTY
dosage
dose putty material using measuring spoon
impress the edge of the spoon into the selected putty
2 strand-lengths of the catalyst (8 cm) per 1 spoon
An excess amount of catalyst shortens the working
and the setting times.

4. PREPARING SILOFLEX PLUS PUTTY
mixing
knead the substance thoroughly to achieve a homogeneous colour without pink stripes
!!! Work in protective gloves only !!!

5. Method of double impression PUTTY APPLICATION
on the tray
Inserting into
the mouth
Outlet holes cutting
Impression

6. PUTTY

7. PREPARING SILOFLEX PLUS LIGHT
dosage
mixing
1:1
30 s
mix until a homogeneous colour is achieved, spread thoroughly along the pad to achieve a smooth consistency without bubbles

8. Method of double impression LIGHT APPLICATION
Applying Light to the tray
Inserting and fixing in the mouth

9. Method of double impression

10. IMPRESSION - PROCESSING
Impression - disinfection
Disinfection in standard disinfection solution (e. g. Jodisol diluted with water at a ratio of1:10)
Store the impression at room temperature (up to 25 ºC)
Plaster can be placed in the impression 30 minutes from removal of the impression from the mouth
There are no time limitations, but it is recommended to cast within 4 hours.

11. Mistakes in preparation
PREPARING SILOFLEX PLUS
Mistakes in preparation
non-homogeneous mixing – it can cause a foliated impression
Too quick setting, resp. no setting due to mixing ratio
Bad reproduction – impression at the end of working time

12. Thank you for your attention!