1. Comments on LC TGbb PHY Evaluation Methodology Simulation Calibration
May 2015
doc.: IEEE /0496r1
March 2019
Comments on LC TGbb PHY Evaluation Methodology Simulation Calibration
Date: March 13, 2019
Authors:
Jaesang Cha (SNUST)
Edward Au (Marvell Semiconductor)

2. Introduction Two documents proposed for PHY evaluation methodology
March 2019
Introduction
Two documents proposed for PHY evaluation methodology
by Volker Jungnickel (Fraunhofer HHI)
by Nikola Serafimovski (pureLiFi)
In PHY evaluation methodology document, some PHY simulation calibration on these documents are suggested
To generalize PHY evaluation methodology for possible PHY schemes
Jaesang Cha (SNUST)

3. Comments on PHY Evaluation Methodology Simulation Calibration
May 2015
doc.: IEEE /0496r1
March 2019
Comments on PHY Evaluation Methodology Simulation Calibration
The document title used on the doc is “PHY Evaluation Methodology Simulation Calibration”
Change to “PHY Evaluation Methodology Simulation Calibration Procedure”
No description for clause “1 Introduction”
Add the following description for clause “1 Introduction”
Text to add “This document introduce the procedure for simulation calibration of TGbb PHY proposals.”
Subclause 2.1 title is given as “802.11a”
Is it right for TGbb system model block diagram or “802.11a” system model block diagram
Change subclause title to “PHY TX-RX System Model Block Diagram”
Jaesang Cha (SNUST)
Edward Au (Marvell Semiconductor)

4. Comments on PHY Evaluation Methodology Simulation Calibration…Cont.
May 2015
doc.: IEEE /0496r1
March 2019
Comments on PHY Evaluation Methodology Simulation Calibration…Cont.
Figure citations used as a “Figure XX”
Change to “Figure 1”
Insert Figure citations and Figure Name
Insert Figure citations as “Figure 1”
Insert Figure name as “Figure PHY TX-RX System Model Block Diagram”
Only DCO-OFDM is referenced in the PHY Evaluation Methodology in doc
Is it mandatory uses Only DCO-OFDM for Simulation
Any other scheme can be considered like ACO-OFDM
Jaesang Cha (SNUST)
Edward Au (Marvell Semiconductor)

5. Comments on PHY Evaluation Methodology Simulation Calibration…Cont.
May 2015
doc.: IEEE /0496r1
March 2019
Comments on PHY Evaluation Methodology Simulation Calibration…Cont.
MCS referred only “QPSK” in the PHY Evaluation Methodology in doc
Is it mandatory to use only QPSK for Simulation
How about QAM?
Jaesang Cha (SNUST)
Edward Au (Marvell Semiconductor)

6. May 2015
doc.: IEEE /0496r1
March 2019
References
[1]
[2]
Jaesang Cha (SNUST)
Edward Au (Marvell Semiconductor)