Presentation is loading. Please wait.

Presentation is loading. Please wait.

Fig. 2 Device characteristics.

Published byHelen Berger Modified over 5 years ago

Similar presentations

Presentation on theme: "Fig. 2 Device characteristics."— Presentation transcript:

1 Fig. 2 Device characteristics.
Device characteristics. (A) Measured subthreshold emission spectra (T = 10 K). Two peaks separated by the AlAs reststrahlen band were observed, stemming from the emission from the lower and upper phonon-polariton branches, respectively. The low-temperature laser spectrum at 880 mA is also shown. a.u., arbitrary units. (B) Measured Raman spectrum taken from the active region in the z(x,y)z¯ geometry. (C) Room-temperature direct transmission spectrum using a room-temperature deuterated triglycine sulfate detector. (D) Light output versus current characteristic. A single threshold current (=880 mA) was observed. The inset shows the transport curve of the device. The ridge width of the device is ~30 μm, and the length was 250 μm. Keita Ohtani et al. Sci Adv 2019;5:eaau1632 Copyright © 2019 The Authors, some rights reserved; exclusive licensee American Association for the Advancement of Science. No claim to original U.S. Government Works. Distributed under a Creative Commons Attribution NonCommercial License 4.0 (CC BY-NC).

Download ppt "Fig. 2 Device characteristics."

Similar presentations

Fig. 2 Nonlinearities in a cavity-embedded perovskite single crystal.

Fig. 2 Nonlinearities in a cavity-embedded perovskite single crystal.
Fig. 4 Altitudinal distributions of ice thickness change (m year−1) for the 650 glaciers. Altitudinal distributions of ice thickness change (m year−1)

Fig. 4 Altitudinal distributions of ice thickness change (m year−1) for the 650 glaciers. Altitudinal distributions of ice thickness change (m year−1)
Fig. 2 Transport properties of a BP transistor at low temperature.

Fig. 2 Transport properties of a BP transistor at low temperature.
Fig. 1 Characterization of the device structure.

Fig. 1 Characterization of the device structure.
Fig. 4 Ballistic simulation of BP FETs.

Fig. 4 Ballistic simulation of BP FETs.
Fig. 2 Global production, use, and fate of polymer resins, synthetic fibers, and additives (1950 to 2015; in million metric tons). Global production, use,

Fig. 2 Global production, use, and fate of polymer resins, synthetic fibers, and additives (1950 to 2015; in million metric tons). Global production, use,
Fig. 3 Vibrational spectra of human bones from the Copper Age (Scoglietto cave, Italy). Vibrational spectra of human bones from the Copper Age (Scoglietto.

Fig. 3 Vibrational spectra of human bones from the Copper Age (Scoglietto cave, Italy). Vibrational spectra of human bones from the Copper Age (Scoglietto.
Vibrational spectra of medieval human bones (Leopoli-Cencelle, Italy)

Vibrational spectra of medieval human bones (Leopoli-Cencelle, Italy)
Fig. 3 Projected gains in MCP.

Fig. 3 Projected gains in MCP.
Fig. 5 Thermal conductivity of n-type ZrCoBi-based half-Heuslers.

Fig. 5 Thermal conductivity of n-type ZrCoBi-based half-Heuslers.
Fig. 1 Map of water stress and shale plays.

Fig. 1 Map of water stress and shale plays.
Fig. 1 Crystal and electronic structure of WTe2.

Fig. 1 Crystal and electronic structure of WTe2.
Fig. 3 Saturation velocity of BP FETs.

Fig. 3 Saturation velocity of BP FETs.
Fig. 3 Electron PSD in various regions.

Fig. 3 Electron PSD in various regions.
Fig. 4 Resynthesized complex boronic acid derivatives based on different scaffolds on a millimole scale and corresponding yields. Resynthesized complex.

Fig. 4 Resynthesized complex boronic acid derivatives based on different scaffolds on a millimole scale and corresponding yields. Resynthesized complex.
Fig. 6 PL study showing the lower energetic states at the layer edges.

Fig. 6 PL study showing the lower energetic states at the layer edges.
Fig. 3 Glucose- and structure-dependent insulin release.

Fig. 3 Glucose- and structure-dependent insulin release.
Fig. 3 Scan rate effects on the layer edge current.

Fig. 3 Scan rate effects on the layer edge current.
Fig. 3 Rotation experiment, setup.

Fig. 3 Rotation experiment, setup.
Fig. 1 Product lifetime distributions for the eight industrial use sectors plotted as log-normal probability distribution functions (PDF). Product lifetime.

Fig. 1 Product lifetime distributions for the eight industrial use sectors plotted as log-normal probability distribution functions (PDF). Product lifetime.

Similar presentations

Ads by Google