1. MATH, CHARTS, AND CALCULATIONS14
MATH, CHARTS, AND CALCULATIONS
MATH, CHARTS, AND CALCULATIONS

2. Figure Valve clearance allows the metal parts to expand and maintain proper operation, both when the engine is cold or at normal operating temperature. Adjustment is achieved by changing the thickness of the adjusting shim.
Figure Valve clearance allows the metal parts to expand and maintain proper operation, both when the engine is cold or at normal operating temperature. Adjustment is achieved by changing the thickness of the adjusting shim.

3. FREQUENTLY ASKED QUESTION: How Is Metric Fuel Economy Measured
FREQUENTLY ASKED QUESTION: How Is Metric Fuel Economy Measured? In the United States fuel economy is expressed in miles per gallon. Outside of the United States, fuel economy is measured in the number of liters of fuel needed to travel 100 kilometers (62 miles), abbreviated L/100 km. This means that as the number increases, the fuel economy decreases. For example: MPG L/100 km In the metric system, the fuel is measured; in the United States, the miles are measured.
FREQUENTLY ASKED QUESTION: How Is Metric Fuel Economy Measured? In the United States fuel economy is expressed in miles per gallon. Outside of the United States, fuel economy is measured in the number of liters of fuel needed to travel 100 kilometers (62 miles), abbreviated L/100 km. This means that as the number increases, the fuel economy decreases. For example: MPG L/100 km In the metric system, the fuel is measured; in the United States, the miles are measured.

4. Figure The drive gear is attached or is closer to the power source and rotates or drives the driven gear.
Figure The drive gear is attached or is closer to the power source and rotates or drives the driven gear.

5. Figure If the driven gear is rotating faster than the drive gear, it is called an overdrive ratio.
Figure If the driven gear is rotating faster than the drive gear, it is called an overdrive ratio.

6. Figure 14-4 A graph showing horsepower and torque
Figure A graph showing horsepower and torque. Notice that the curves cross at 5252 RPM or a little bit to the right of the 50, which is expressed RPM is expressed as the graph number multiplied by 100. Example is 52 multiplied by 100 equals 5200 RPM. The torque and horsepower curves cross at 5252 RPM because torque is measured by a dynamometer and then horsepower is calculated using a formula which causes both values to be the same at that one engine speed.
Figure A graph showing horsepower and torque. Notice that the curves cross at 5252 RPM or a little bit to the right of the 50, which is expressed RPM is expressed as the graph number multiplied by 100. Example is 52 multiplied by 100 equals 5200 RPM. The torque and horsepower curves cross at 5252 RPM because torque is measured by a dynamometer and then horsepower is calculated using a formula which causes both values to be the same at that one engine speed.

7. Figure 14-5 A typical chart showing what is applied in what gear in an automatic transmission.

8. Figure 14-6 An exploded view showing how the thermostat is placed in the engine.