1. Milling Circles and Arcs and Milling with Canned Cycles
11/20/08

2. Review: Straight Lines
Initiated by MOVE command

3. Circles Move the mill to the start of circle
Put in arc mode with ARC.CW or ARC.CCW
Specify center point
Specify ARC

4. Arcs Move the mill to the start of circle
Put in arc mode with ARC.CW or ARC.CCW
Specify center point
Specify end point

5. Arcs
Z matters

6. Cylindrical Pockets Move the mill to the start
Start pocket cycle with # sides and depth of each pass
Specify center point and final depth
Specify ARC

7. Pockets Move the mill to the start
Start pocket cycle with # sides and depth of each pass
Specify center point and final depth
Specify end point

8. Cups Move the mill to the start
Start cup cycle with # sides and depth of each pass
Specify center point and final depth
Specify ARC

9. Cups Move the mill to the start
Start cup cycle with # sides and depth of each pass
Specify center point and final depth
Specify ARC

10. Partial Cups Move the mill to the start
Start cup cycle with # sides and depth of each pass
Specify center point and final depth
Specify end point

11. Partial Cups Move the mill to the start
Start cup cycle with # sides and depth of each pass
Specify center point and final depth
Specify end point

12. Drill
Drills holes
Begin with DRILL
Specify points
End with FINISH