1. Comments on HO decision and initiation (16.2.6.3.2)
IEEE Presentation Submission Template (Rev. 9)
Document Number:
IEEE C802.16m-10/0380r1
Date Submitted:
Source:
Shih-Yuan Cheng, Whai-En Chen
National Ilan University
Shiann-Tsong Sheu, Chih-Cheng Yang National Central University
Kanchei(Ken) Loa, Yi-Ting Lin, Tsung-Yu Tsai,
Youn-Tai Lee, Chun-Yen Hsu, Chiu-Wen Chen
Institute for Information Industry
Yang-Han Lee, Yih Guang Jan Tamkang University
*<
Venue: IEEE Session#66, Orlando, Florida, USA.
Re: IEEE /0011, “IEEE Working Group Letter Ballot#31”, on P802.16m/D4
Base Contribution: This is base contribution.
Purpose:
To be discussed and adopted by TGm for m LB#31.
Notice:
This document does not represent the agreed views of the IEEE Working Group or any of its subgroups. It represents only the views of the participants listed in the “Source(s)” field above. It is offered as a basis for discussion. It is not binding on the contributor(s), who reserve(s) the right to add, amend or withdraw material contained herein.
Release:
The contributor grants a free, irrevocable license to the IEEE to incorporate material contained in this contribution, and any modifications thereof, in the creation of an IEEE Standards publication; to copyright in the IEEE’s name any IEEE Standards publication even though it may include portions of this contribution; and at the IEEE’s sole discretion to permit others to reproduce in whole or in part the resulting IEEE Standards publication. The contributor also acknowledges and accepts that this contribution may be made public by IEEE 802.1
Patent Policy:
The contributor is familiar with the IEEE-SA Patent Policy and Procedures:
< and <
Further information is located at < and < >.

2. Introduction In current D4 page 207 line 21:
The AMS shall not perform HO to a cell with Cell Bar bit=1 in its S-SFH.
The “Cell Bar” bit, when set, indicates that an AMS should not perform network entry or re-entry to this cell.

3. Motivate In page 207 line 28 states that
The AAI-HO_CMD message should not include an ABS with cell bar information =1.
In page 294 line 48 states that
If the AMS reads cell_bar=1 in SFH, this means this cell does not allow access of new AMS and the AMS shall select a different cell to restart network entry procedure.
In page 317 line 30 states that
If the preferred ABS has Cell Bar bit=1 in its S-SFH, the AMS should re-select other ABS for network re-entry.
In page 450 line 47 states that
If Cell Bar bit = 1, this cell is not allowed for network entry or re-entry

4. Problem Statement To clean up the texts in the current D4.
The AMS shall not perform HO, network entry or re-entry to a cell with Cell Bar bit=1 in its S-SFH.

5. Proposed Text
[Modify the following text in section “HO decision and initiation”]
The AMS shall not perform HO, network entry or re-entry to a cell with Cell Bar bit=1 in its S-SFH. The “Cell Bar” bit, when set, indicates that an AMS should not perform network entry or re-entry to this cell.