1. A lidded box with a snug fitting lid
“Bobbin Box”
A lidded box with a snug fitting lid

2. Simple Steps Eight side the stock Round the stock Apply glue block
True glue block
Apply second and true.
Layout lid.
Remove lid.

3. Simple Steps …… Turn lid and create groove
Finish the interior of the lid.
Mount the bottom
Hollow, create the tenon. (tendon)
Finish the interior
Allow to cure
Fit the lid, using wax.

4. Simple Steps ….. Bring up the soft touch* Shape the lid and box
Sand to finish.
Remove from glue block
Create jamb chuck
Detail the bottom of box.

5. Mount on glue block

6. True face and add second block

7. Part off top third

8. Lay out center and edges

9. Hollow Center, add recess

10. Mount base, layout from top

11. Hollow Center, Sand
Chatter?

12. Create tenon

13. Add groove for “O” Ring

14. Add “O” Ring and fit lid

15. Install Lid and begin shaping

16. Bring up a “soft touch” tip

17. Shape lid to suit

18. Secure lid for finishing

19. Create a jamb chuck

20. Bring up a “Soft Touch”

21. To reshape, sand, finish.

22. The Bobbin Box