Download presentation
Presentation is loading. Please wait.
Published byBrendan Brisker Modified over 10 years ago
1
Hofmann Alignment Adjustment Features Training A-ARM Adjustment
2
Why would the Technician want to make an adjustment?
3
Low Caster on right side and High Camber on right side resulting in a Pull condition to the Right.
7
This Screen is indicating to move the front of the Upper A-Arm in, and the rear of the Upper A-Arm in
8
Select the Jack icon to Toggle from Elevated or Turntable adjustment
9
If the adjustments are on the Lower Control Arm, Click on the icon to Toggle to the Lower A Arm
10
It would now be necessary to move the Lower A-Arm out at the front and out at the rear
11
As you move the A-Arm, in the indicated direction, the scale will move towards the center.
12
This screen shows the left side adjustment
13
Because the left side is near desired, the Technician may skip past the left side adjust screen by clicking on the green icon
15
Caster and Camber adjustments will normally change the Toe setting. It will now be necessary to adjust the Toe
16
A-Arm adjust mode will use the preferred specification as the desired end result. If a setting other than preferred is desired, edit the specifications and make the desired setting the preferred
17
Caster and Camber set to factory preferred Preferred Caster and Camber altered to help offset road crown pull
18
Wwwww W
Similar presentations
© 2025 SlidePlayer.com. Inc.
All rights reserved.