1. TITLE: Pilot Diameter Measuring SWI:REVISION:DATE:PAGES:WORK STATION: MI Shop-Pilot Dia.A2014-1-2# OF 4Shop Technology in Motion STANDARD WORK INSTRUCTION Trained and capable of performing this work: Date: Supervisor or engineer giving Approving to perform: Operator 2 Operator 5 Operator 6 Operator 4 Operator 1 Operator 3 On this page is information about operators that are trained and certified to perform this Standard Work. The operators signing below have read this SWI and have successfully performed the work described in it in the presence of the Supervisor or Engineer signing in the second column on the date in the third column.

2. TITLE: Pilot Diameter Measuring SWI:REVISION:DATE:PAGES:WORK STATION: MI Shop-Pilot Dia.A2014-1-2# OF 4Shop Technology in Motion STANDARD WORK INSTRUCTION Safety Requirements:Safety glasses In Process Check 1) 21°C and 27°C. 2) 180° Be sure the anvil and spindle of the micrometer are 180° apart when taking the measurement. 3) Be sure the measuring surfaces of the micrometer are properly seated on the pilot diameter and not the fillet. 4) 1.. Operator Maintenance 1) 2) 3) 4) 5) Material / Components 1) Motor or End cap to be tested 2) 3) 4) Tools & Fixtures 1) V-blocks 2) Blade Micrometer 3) 4) 5) 2. 3. 90

3. TITLE: Pilot Diameter Measuring SWI:REVISION:DATE:PAGES:WORK STATION: MI Shop-Pilot Dia.A2014-1-2# OF 4Shop Technology in Motion STANDARD WORK INSTRUCTION Safety Requirements:Safety glasses Operator Maintenance 1) 2) 3) 4) 5) Material / Components 1) 2) 3) 4) 5) Tools & Fixtures 1) Micrometer 2) 3) 4) 5) 4. 2&3. In Process Check 1) Parts must be between 21°C and 27°C during inspection process. 2) Be sure the anvil and spindle of the micrometer are 180° apart when taking the measurement. 3) Be sure the measuring surfaces of the micrometer are properly seated on the pilot diameter and not the fillet. 4)

4. TITLE: Pilot Diameter Measuring SWI:REVISION:DATE:PAGES:WORK STATION: MI Shop-Pilot Dia.A2014-1-2# OF 4Shop Technology in Motion STANDARD WORK INSTRUCTION Signatures of Authorization Production:Manufacturing:Quality:Design:Other: Revision:Date:Reason for Change:Editor: A8/8/2006New SWI Introduction.Chris Adams